If it has etched the glass,there is no way to remove it.
Etched glass designs are typically applied to the outside surface of the glass door to protect the decorative elements and prevent wear and tear from everyday use. Placing the etching on the inside could increase the risk of damage and make it harder to clean and maintain.
To replace a glass panel in a door with wood, you will need to measure the dimensions of the glass panel and cut a piece of wood to fit. Remove the glass panel and insert the wood piece in its place, securing it with adhesive or screws. Sand and paint the wood to match the door, if desired.
break the glass
Lower the glass, open the door, pull off the arm rest, pull the door panel, remove insulation , remove the inner glass stabilizers, front door-remove the guide slide, support the btm. Of glass, remove the 2 mounting bolts holding glass to the regulator. Tilt glass up and out of door, remove the regulator-door bolts, disconnect the electric wiring connector, remove the regulator thru the door opening.
Carefully.
Check with the craft store.
Remove outer door skin(if you need directions for this try your local library for a service manual)lower window glass remove glass nuts with toolSA9148B push glass up and rotate slightly remove door glass reverse procedure to install glass
remove door handles x2 ,crank and lever (2 screws each) remove cards remove the bolts 10mm seen on door connected to regulator. remove regulate remove glass from reg. rev, for back (use caulk to hold glass in reg bottom)
Use thinner for that paint.
To replace the glass in a door, you will need to remove the door from its hinges, take out the old glass, measure the dimensions of the glass, purchase a new piece of glass that fits those dimensions, and then install the new glass into the door frame. Finally, reattach the door to its hinges.
To effectively remove paint from a door, you can use a chemical paint stripper or a heat gun to soften the paint, then scrape it off with a putty knife or a paint scraper. Be sure to wear protective gear and work in a well-ventilated area.
To remove the door glass on a 1970 VW Beetle, first, remove the door panel by unscrewing any screws and gently prying it off. Next, lower the glass fully and detach the window regulator by unscrewing the bolts. Carefully lift the glass out of the window frame, ensuring you detach any clips or guides. Finally, remove the glass from the door, taking care to avoid any sharp edges.