To remove the fuel pump from a Fiat Punto, first, disconnect the negative battery terminal to ensure safety. Then, access the fuel pump by removing the rear seat or the trunk cover, depending on the model. Disconnect the fuel lines and electrical connectors from the pump, and unscrew the retaining ring or screws securing the pump in place. Finally, lift the fuel pump assembly out of the tank carefully to avoid spills.
In the Tank.
Yes
Under the rear seats. Remove 3 screws from the metal plate and there it is.
if its on a punto gt is a lot of work.have to remove inlet manifold costs a lots for the job to be done in a garage.
under passenger side glove compartment. It is a dual combo relay.
remove plastic wheel arch liner remove power steering pump you can leave pipes on .then remove p.a.s pump bracket may have to remove water pump pullly and remove alt from top
The fuel pump relay on a Fiat Punto Diesel is typically located in the engine compartment fuse box. To access it, open the hood and locate the fuse box, which is usually situated near the battery. The relay can be identified by consulting the diagram on the cover of the fuse box, as it will indicate the specific location of the fuel pump relay. If you're unsure, referring to the vehicle's service manual can provide additional guidance.
The fuel pump is located under the rear seat, it is very easy to get to but be careful it is very delicate! when removing the two fuel pipes be very careful as the connectors are weak, push the tab on the side of the fuel pipe connectors and at the same time pull them away from the fuel pump, then you unscrew the large plastic nut and pull out the fuel pump.
in the fuel tank
it is on the steering column below the steering wheel
If you bypass the fuel pump the car will not run.
In a 1995 Fiat Punto, the fuel pump fuse is typically located in the fuse box, which is usually found in the engine compartment or under the dashboard on the driver's side. You can identify the specific fuse for the fuel pump by referring to the fuse diagram, which is often printed on the inside cover of the fuse box or in the owner's manual. It’s usually a small blade fuse, so ensure to check the amperage rating to confirm you have the correct one.