To remove the Peugeot number plate bulb holder, first, ensure the vehicle is turned off and the key is removed. Gently pry open the holder using a flathead screwdriver or a similar tool, being careful not to damage the surrounding area. Once loose, pull the holder out of its socket, and disconnect the bulb from the holder if necessary. Always replace with a new bulb holder if needed, and reassemble by reversing the steps.
To change the number plate bulb on a Peugeot 106, first, open the boot and locate the light housing for the number plate. Carefully pry off the light cover using a flathead screwdriver or your fingers. Remove the old bulb by twisting it out of the socket, then insert the new bulb and reattach the light cover. Finally, test the new bulb by turning on the ignition and checking the number plate light.
Have to remove the doorliner from the rear door. Remove the 2 screws that hold the black trim that covers the lamps. Then you can remove the clear cover and access the lamp.
Remove backing plate on headlight unit.
To change the number plate light on a Peugeot Expert van, first, locate the light assembly above the number plate. Use a flat-head screwdriver to gently pry off the cover or housing. Once exposed, remove the old bulb by twisting it out of the socket and replace it with a new bulb, ensuring it fits securely. Finally, reattach the cover and test the light to ensure it's working properly.
Open trunk, plate fits through a slot--just push up from the outside front of plate
A plate holder is a pad or sheet placed under the plate, either for cleanliness or for decorative purposes.
take off the license plate then screw the holder on with the plate.
In the sedan you remove the bulb holder in the boot lid by twisting and pulling thn push the bulb down in the holder and twist then pull out
Prise the holder out of the bumper, then the bulb is accessible
you should find it on the bulkhead at the rear of the engine compartment.
the pollen filter is under the dashboard passenger side behind the centre console remove the the black cover plate and pull it out
a large paper plate is your foods holder!