To remove the plastic engine cover on a 2007 Renault Clio, first, make sure the engine is cool. Locate the securing clips or bolts holding the cover in place, usually found at the edges. Gently pry up the clips or unscrew the bolts with the appropriate tool. Once released, lift the cover off carefully to avoid damaging any attached components.
Pull it off
They are in the center of the Valve cover, under the plastic "chunks" that are the ignition coils. You might need to remove the plastic engine cover first. There are several plastic clips you need to turn part way to remove this part.
check this out, it's same engine as in Rabbit http://rabbitownersclub.com/vw/showthread.php/engine-plastic-cover-4981.html
You remove the large plastic engine cover from the top of the engine (remove the three plastic caps, then loosen the three 10mm nuts). It's right on the front top of the engine under a plastic cap about 3" in diameter.
To remove the plastic engine cover from a 2005 Cadillac SRX, first, locate the retaining bolts or clips securing the cover. Use a socket wrench to remove the bolts or carefully pry off the clips with a flathead screwdriver. Once the fasteners are removed, gently lift the engine cover straight up to detach it from the engine. Be cautious not to damage any underlying components during the removal process.
PCV valve is located in front of the engine, behind plastic (long and narrow plastic cover that covers valves and fuel lines). You need to remove one hex screw that attaches plastic cover to engine and remove plastic cover. You will see pcv valve 3-4 inches to the right of the hex screw that was attaching plastic cover to engine. Once removed you will see silver pipe at the end of the pipe plugged in engine sits PCV valve. PCV valve plugged into engine by it's mettalic side, so only plastic side is visible. Easiest way to understand how PCV valve sits is to buy new valve in auto parts store, remove plastic cover that covers fuel lines in front of engine and find a part that looks like PCV valve.
How to remove drivers' side light cover
It will not take long at all to remove door trim from a Renault Menage. All you have to do is remove the bottom 10 mm bolts on the door, un-clip the door lights, undo the plastic trimming from the clips, unscrew the door cover and then remove all trimming.
it is in front of the driver side under plastic scuttle panel where wiper arm bolted.. lift off cover and remove plastic insert, wiper motor is in front of you now..
Take a stanley blade and take it all the way round the plastic on the light it will then remove.. take a bit of bonding gliue and put the new plastic on
To remove the plastic engine cover on a 2006 Buick LaCrosse, first, ensure the engine is cool. Locate the fasteners or clips securing the cover, which are usually located around the perimeter. Use a socket wrench or pliers to remove any screws or clips, then gently lift the cover off, taking care not to damage any attached components or wiring. If necessary, consult your vehicle's manual for specific instructions related to your engine type.
It is on the top rear of the valve cover. You will have to remove the plastic cover on the top of the engine to access.