To remove the alternator from a 1989 Cutlass Ciera, first disconnect the negative battery terminal to ensure safety. Next, remove the drive belt by loosening the tensioner, then unbolt the alternator from its mounting bracket. Disconnect the electrical connections from the alternator, and finally, lift it out of the engine compartment. Be sure to follow any specific vehicle service manual instructions for detailed steps and torque specifications.
How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera? or where can I get the Info on replaceing it
Generally, no. The alternators for a 1989 vs. 1995 have adjusting ears on opposite sides, the internal bearings are somewhat larger/stronger on the 1995 model, and most importantly, the amperages differ, so there would be inadequate output if you were to put a 1989 alternator on a 1995 vehicle (the 1989 alternator is an 85amp, vs. 105 amp on the 1995). These guidelines are based on the assumption that you have a 4-cylinder model. If you have a V-6 engine, the differences are similar-- different mounting ears and different amperages.
Chain
fuse
300.00
Unplug the wire on the side,remove the screw on it,,pull it off and replace with new one.
By the fuel tank , left side where the filler tube is.
To remove the rear brake drums on a 1989 Oldsmobile Cutlass Ciera, first ensure the vehicle is safely lifted and supported on jack stands. Remove the wheel and tire, then locate the brake drum. If the drum is stuck, tap around the edges with a hammer to loosen it, and if necessary, remove the adjuster access plug to back off the brake shoes. Finally, slide the drum off the wheel hub.
An exploded view of the heater controls for a 1989 Olds Cutlass can be found in the Cutlass service manual. The manual can be found at most auto parts.
4.5 or 4 1/2 quarts..
where is the horn relay
To access the front speakers in a 1989 Oldsmobile Cutlass Ciera, first, remove the door panels by unscrewing any visible screws and gently prying off the panel to detach it from the clips. Once the panel is off, you’ll see the speaker mounted in the door. Disconnect the wiring harness from the speaker, and then unscrew it from its bracket to remove it. Reassemble in reverse order after replacing or inspecting the speakers.