I had the same problem on my 420 SEL, you first have to remove the window wiper fluid container and after you can reach the screws for the battery after that it is simple.
it is easy if you remove the exhast so you can get to the starter bolts
blaupunct
Torque specs for WATER PUMP Mercedes 420 SEL are: 7.3 diesel and 15 to 18 foot pounds of torque
The gap for your 420 sel is .32... dont forget to use a good plug!
On a 1990 Mercedes 420 SEL, the overload protection relay is typically located in the engine compartment, near the fuse box. It can often be found mounted on the inner fender or near the battery. To access it, you may need to remove some covers or components. Always consult the vehicle's service manual for precise locations and instructions.
answer
To remove the ashtray from a 1991 Mercedes-Benz 420 SEL, first, open the ashtray door and locate the release tab or screws that hold it in place. If there are screws, use a screwdriver to remove them. Gently pull the ashtray out of its housing, being careful not to damage any surrounding components. Once free, you can clean or replace it as needed.
To remove a Mercedes 420 SEL cylinder head, first, disconnect the battery and drain the coolant. Next, remove the intake and exhaust manifolds, along with any connected components such as the fuel lines and electrical connectors. Then, loosen the head bolts in the specified sequence to prevent warping, and carefully lift the cylinder head off the engine block. Ensure to inspect the mating surfaces and replace any gaskets as needed during reassembly.
I would ask Google.
1295 kg if it has a 126 v8 engine
Check fuse box - fuse #14
i would like to know the layout of the sunroof. thank you.