On a 1991 Jaguar Sovereign, the fuel pump is located inside the fuel tank. To access it, you typically need to remove the tank from the vehicle, as the pump is not externally accessible. It's advisable to refer to the vehicle's service manual for specific instructions and safety precautions when performing this task.
You have to Jack up the car, and reach above the rear end , remove the 2 clips holding the fuel lines and give them a slight twist and pull. This will remove the hoses. Then you will have to remove the hoses and straps and wiring in the trunk, in order to remove the tank.
You have to Jack up the car, and reach above the rear end , remove the 2 clips holding the fuel lines and give them a slight twist and pull. This will remove the hoses. Then you will have to remove the hoses and straps and wiring in the trunk, in order to remove the tank.
To change the speakers in a 1991 Jaguar Sovereign, first, carefully remove the door panel using a flathead screwdriver to detach clips and screws. Once the panel is off, locate the existing speakers, disconnect the wiring harness, and unscrew the speakers from their mounts. Replace them with the new speakers, reconnect the wiring, and reassemble the door panel securely. Make sure to test the new speakers before finalizing the installation.
To reset the transmission light in a 1991 Jaguar Sovereign, first ensure that the vehicle is in park or neutral. Disconnect the battery for about 10-15 minutes to reset the electronic control module. After reconnecting the battery, start the vehicle and check if the transmission light has turned off. If it remains illuminated, it may indicate a persistent issue that requires further diagnosis.
i have a 1991 sovereign xj6 and i have the same problem, BUT the gauge would show correct levels when accelerating
I found that if you drop the hole engine and cradle from the bottom of the car it is much easier
Remove the fan shroud remove the radiator remove the fan there is a fan in front of the radiator fan, loosen the sway bar on that and lower it a little so you can remove that belt loosen the alternator sway bar belt should be loose... replace belt reverse to put everything back you will need a ratchet and 10mm socket keep track of your bolts. Good luck!
1991 jaguar jx6 will not start
Remove the door panels and lubricate everything that moves. Fixes 95% of them!
£30,000 to £76,000
To remove the headlight on a 1991 Nissan Pulsar N13 Vector sedan, start by opening the hood and locating the headlight assembly. Disconnect the electrical connector and then remove the screws or bolts that secure the headlight assembly in place. Carefully pull the headlight out of the housing, taking care not to damage any clips or wiring. Finally, replace or reinstall the new headlight by reversing the steps.