If its a 98 60sx mk1 punto then you have to take out the screws at the bottom of the door pockets then use a flat screwdriver to pop it out from the bottom workin your way to the top an lift it round the lever that opens the door then over the locking pin.
A pipe inside the rear hatch has diconnected, simply remove the plastic inner panel inside the hatch and reconnect
If you undo the fuse box panel to the right of the steering wheel it is the cylindrical item to the left inside there
To remove the window switch on a Fiat Punto front door, start by using a flathead screwdriver to gently pry off the trim panel surrounding the switch. Once the panel is removed, locate the screws securing the switch and unscrew them. Then, carefully disconnect the wiring harness attached to the switch. Finally, you can pull the switch out from its housing.
Fiat Punto was created in 1993.
The Fiat Punto is manufactured by the company Fiat. Fiat is an Italian manufacturing company. The manufacturing of the Fiat Punto started in 1993 and is still currently being produced.
Use hammer.
To remove the heater control panel from a Fiat Punto, first ensure the vehicle is turned off and disconnect the battery for safety. Use a flathead screwdriver or a trim removal tool to carefully pry off the surrounding trim panel, taking care not to damage it. Once the trim is removed, unscrew the screws securing the heater control panel and gently pull it out, disconnecting any electrical connectors as needed. Reassemble in reverse order after any repairs or replacements.
Open panel in front of button for sunroof, there is a manual close inside the tool for closing is on the back of the panel you remove dont think you can without taking door trim off make sure fuse is ok then switch
To change the front speakers on a 2002 Fiat Punto, start by removing the door panel. Use a trim removal tool to carefully pry off the panel, and then unscrew any screws that secure it. Once the panel is off, disconnect the speaker wiring, remove the old speakers, and install the new ones by connecting the wiring and securing them in place. Finally, reattach the door panel and ensure everything is properly fitted.
The ECU is located under the Scuttle panel at the base of the windscreen
No its different
Fiat Punto 1.9l ltd service manual?