To remove the window switch on a Fiat Punto front door, start by using a flathead screwdriver to gently pry off the trim panel surrounding the switch. Once the panel is removed, locate the screws securing the switch and unscrew them. Then, carefully disconnect the wiring harness attached to the switch. Finally, you can pull the switch out from its housing.
right next to, and in front of, the oil filter
Use hammer.
On a mk1 I paid £70 which included fitting.
Open panel in front of button for sunroof, there is a manual close inside the tool for closing is on the back of the panel you remove dont think you can without taking door trim off make sure fuse is ok then switch
mel de polo de cambrio
To remove the front seat from a Fiat Punto, first, slide the seat all the way back to access the rear bolts. Use a socket wrench to remove the bolts securing the seat to the floor. Next, tilt the seat forward to access and remove the front bolts. Finally, disconnect any electrical connectors (if applicable) and carefully lift the seat out of the vehicle.
Could be a problem with the 'self parking' switch gone faulty The switch is under the metal cover of the actual wiper motor - so you would need to remove the motor to investigate further Hope this helps
take window adjuster case of...remove the nut, is there a special tool to remove the mirror unit. There is a thread on the new mirror which goes into the door
To fit a door window in a Fiat Punto, first, remove the door panel by unscrewing the fasteners and carefully prying it off. Next, detach the old window by unbolting it from the regulator and sliding it out. Position the new window in place, secure it to the regulator, and then reassemble the door panel by reversing the removal steps. Finally, test the window's operation to ensure it moves smoothly.
1. what is the problem of fiat punto front suspension 2. what is the mantinance of fiat punto front saspension
I'm afraid you cant remove the front head rests, very frustrating as I've brought new seat covers :o(
On the 1998 Fiat Punto GT, the fuel cut-off switch, also known as the inertia switch, is typically located in the passenger compartment, behind the dashboard or near the driver's side footwell. It may be necessary to remove some panels to access it. If you're unable to locate it, consulting the owner's manual or a repair guide specific to the Punto GT can provide more detailed information.