To remove the instrument cluster from a 1995 Jaguar XJS, first disconnect the vehicle's battery to prevent any electrical issues. Then, carefully remove the dash panel surrounding the cluster using a trim tool or screwdriver, taking care not to damage any clips. Once exposed, unscrew the cluster mounting screws and gently pull the cluster forward, disconnecting any wiring harnesses attached to the back. Finally, set the cluster aside for any necessary repairs or replacements.
To remove the instrument cluster from a 1995 Chrysler New Yorker, start by disconnecting the negative battery cable for safety. Next, remove the trim pieces surrounding the cluster by gently prying them off. Unscrew the mounting screws holding the cluster in place, then carefully pull it out from the dashboard. Finally, disconnect the wiring harnesses at the back of the cluster to fully remove it.
You have to remove the instrument cluster to get access to the bulbs.
In a 1995 Volkswagen Golf, the instrument panel bulb is typically located behind the instrument cluster. To access it, you need to remove the instrument cluster by unscrewing the retaining screws and carefully releasing the clips. Once the cluster is out, you can replace the burnt-out bulb from the back of the panel. Make sure to handle the cluster gently and disconnect the battery to avoid any electrical issues.
The bulb is most likely burned out. You have to remove the instrument cluster to replace it.
You hav to remove the inst. cluster and them disassemble it (just remove the back plate) and you will find the bulb in there.
You have to remove the vent & bezel assembly from below the radio first, then the entire dash bezel from around the instrument cluster & radio.
# Disconnect the negative battery cable. # Apply the parking brake and block the rear wheels. # Turn the ignition switch to the OFF position. # Shift the gearshift lever to the 1position. # Position the steering wheel in the full-down position. # Remove the two instrument cluster bezel screws. # Separate the instrument cluster bezel from the instrument panel enough to gain access to the electrical connectors. Disconnect the following electrical connectors: # Rear window wiper/washer switch # Rear window defogger switch # Hazard warning flasher switch # Power E-AT switch, if equipped # Security indicator lamp, if equipped # Cruise control ON/OFF switch # Headlamp switch # Remove the instrument cluster bezel with the switches attached. # Remove the four instrument cluster screws and separate the instrument cluster from the instrument panel. # Position the cluster to gain access to the gearshift indicator. Remove the gearshift indicator from the cluster. # Disconnect the electrical connectors from the instrument cluster and remove the cluster. # The installation is the reverse of removal.
You need to remove the instrument cluster or control panels you want to work on to get access to the bulb holders.
You have to remove the instrument cluster. Easy job to do if you're the least bit handy with a Phillips head screwdriver.
Behind instrument cluster.
There are about 20 of them...any in particular?
On the right side of the instrument cluster.