To remove the wheel arch liner in a Peugeot 106 Independence, first, ensure the vehicle is safely elevated and secure. Start by removing any screws or fasteners holding the liner in place, typically found along the edges. You may need to detach clips or bolts that secure the liner to the body of the car, and then gently pull the liner away from the wheel arch. Be cautious not to damage any surrounding components during the removal process.
There is a series of screw in studs and you have to remove them all and then bend out the arch liner.
Its In the washer bottle which is located inside the front wing. remove wheel and wheelarch liner to gain access to it.
To change the inner wheel arch liner on a Peugeot 307, first, ensure the vehicle is securely lifted and supported. Remove the wheel for easier access, then unscrew and detach the existing liner using the appropriate tools, typically a socket or screwdriver. Once removed, position the new liner in place, align it with the mounting points, and secure it with screws or clips. Finally, replace the wheel, lower the vehicle, and check for a proper fit.
Road..............or steering?
remove road wheel and with a long 5mm Alan key insert straight through the disk until lined up with sensor and remove........hey presto 10mins a side! no need to remove calipers or pads like peugeot say!
To remove a wheel from a Peugeot 307, first ensure the vehicle is on a flat surface and securely supported by jack stands. Loosen the wheel nuts slightly before lifting the car with a jack. Once elevated, fully remove the wheel nuts using a wrench and carefully take off the wheel. Always ensure to re-tighten the wheel nuts in a star pattern when installing the wheel back on.
You cant as no one on the internet will tell you
remove left front tire, remove inner fender liner,Take the left (drivers side) tire off and access the battery inside the wheel well under neath the wheel well liner.
its in the side of the washer bottle located in front of the offside wheel beyond the plastic wheel arch liner, ideally remove o/s/f wheel & liner 1st :-)
It is on the back wall of the left front fender well - remove the tire and wheel - you must remove the wheel well liner to get at it.
In the passenger side wheel arch. You have to remove the wheel & liner to get at the valve.
In the passenger front fender. Remove wheel and fender liner to get it out.