answersLogoWhite

0

Camshaft sensor is located at rear end of rear camshaft(near driver). It is screwed on the little bowl and has a connector attached to it. The little bowl contains the camshaft sensor gear , do not unscrew if not necessary , just replace sensor.

Jules

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do I replace the output shaft speed sensor on my 2001 Kia Optima?

where is the output shaft speed sensor located on a 2001 Kia Optima?


How do you replace a cam shaft sensor and where is it located on a 1990 Pontiac Bonneville?

The cam shaft sensor is located behind the water pump pulley. One bolt that holds it in place.


How do you change crankshaft position sensor?

where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace


Where is the crank shaft sensor located in a Audi a4?

Where is the crank shaft sensor located in a Audi a6


How do you replace a camshaft sensor on a 1999 Tahoe?

The cam shaft position sensor is located under the distributor cap. You can replace this easily by undoing the screws holding on the distributor cap, remove and replace the sensor, then just replace the distributor cap.


Where is the camshaft position sensor located on 1993 Volvo 850 GLT?

on the right side of the engine at the back at the righ end of the cam shaft


How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?

How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?


How do you replace cam shaft sensor on 2006 savanah 3500 6.0L?

Replacing that cam shaft sensor in a 2006 Savannah 3500 can take some time. Changing it can all depend on what the car is and where it is located.


Where is a crank shaft positioning sensor located in a 2003 altima?

It is in the oil pan. Nissan has had a recall to reprogram the sensor. They may have to replace the sensor for free. It cost about $600 for repair.


1989 Volvo 740 gle only runs off of staring fluid then dies?

try changing the crank shaft sensor,which is located on the firewall on the 1991 740 non turbo sedan,i had the same problem and just about a month ago had to replace it.


Where is the Turbine Shaft Speed Sensor located on a 1998 Explorer?

The turbine shaft speed (TSS) sensor is located inside the automatic transmission.


Where is the crank shaft sensor on a 1998 BMW 740il?

The crank shaft sensor on a 1998 BMW 74Oil is located down near the crank on the front of a motor. It is super easy to replace but sometimes reaching the harness wire is a little bit difficult.