To replace the front turn signal light in a 2005 BMW X5, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly, then gently pull it out to access the bulb holder. Twist the bulb holder counterclockwise to release it, replace the old bulb with a new one, and reassemble by reversing the steps. Ensure the assembly is securely in place and test the new bulb before closing the hood.
u go ask a mechanic to do it then pay them for it
To remove signal (corner) light. the light is able to come off by pulling it towards you facing the vehicle. once popped off the light has a plug attached to it, remove it cautiously.
If you are talking about a front turn signal, there is a release tab inside the fender. when you push it it will release the whole light assembly. Then you can access the bulb
there are two screws holding the light assembly to the car. Remove the two and replace after removing headlight
Answer: Replace Hyundai Sonata.
replace bulb in front
You need to remove the head lap it has some scews on the side and on front.
Might be useful to precise what model you need this for... Saturn relay 2005
The front turn signal light bulb can be accessed through the engine compartment. Take hold of the light bulb connector on the back of the turn signal. Push the connector in and turn at the same time. The light bulb will come out.
Replace the rear bulb and be sure the contacts are clean.
you have to open up the hood and take out all the junk and put in the new bulb.
2005 Dodge Stratus front turn signal light bulb lamp replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).