Found this on another web site....don't know how useful it is, but I'll find out myself tomorrow !
Hi I've just changed a bulb and it is very easy - I have a Audi A4 cabriolet and the instructions were not in the manual! So, to save money and not visit a mechanic, here goes!> Open the boot of the car - locate the plastic flat plug, just behind where the rear lights sit. Turn it half or third of a turn and pull it out. (it's just a cover with 3 flanges - like you get on the bottom of a piggy bank!) In that hole there is a screw - undo it and pull it out - it's quite long ~ 5cm. Now the scarey bit..using your finger nails grip all around the edge of the back light fixture/ coloured glass - and if it's the left rear lamp you are gripping push/wiggle to the left....or the opposite for the other side. You see, the only thing really holding the back light fitting to the car is 2 little balls, which stick out from the back of the car like nipples, and actual light casement is slipped onto these sideways when the car is built. Keep wiggling it very slightly while pushing to left. Suddenly it will come away in your hand. Once off locate the bulb that's blown, #REMEMBER to turn the lights off and remove keys from the ignition!#, Give the bulb housing half a turn to remove the bulb-with-the-socket and change the bulb (remove=quarter turn and extract, replace = push bulb in followed by a quarter turn to fix). Be careful to replace the bulb with the right one - you can read the bulb's description from the metal trunk of the bulb itself---eg could be like - 5w 12v for a rear light etc - get them from Halfords 2x for £2.50. Hope it helps Time for Tea!
how to replace the light bulb on the gear shift on 2004 tracker
i need to replace the temperature control light bulb on my 2004 silverado.
Pull the carpeting behind the brake light. Unclip the assembly, replace bulb.
To change a side light bulb on an Audi TT, remove the light lens by unscrewing the screws holding it on. Then, remove the old bulb and insert a new one. Replace the cover and tighten the screws.
How do you replace the rear brake light bulb on a 2001 Honda civic?"
take out the light bulb
To replace the tail light bulb on a 2008 Audi A6, start by opening the trunk and removing the access panel or cover located behind the tail light assembly. Once exposed, twist and remove the bulb holder from the assembly, then pull out the old bulb and replace it with a new one, ensuring it clicks into place. Reinsert the bulb holder back into the assembly, replace the access panel, and test the new bulb to confirm it’s functioning.
How do you replace rear window brake light bulb in the 2004 Hyundai Santa Fe?Read more: How_do_you_replace_rear_window_brake_light_bulb_on_2004_Hyundai_Santa_f_e
is the foglight a one piece unit
To replace the front light bulb on a 2001 Audi A3, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the back of the headlight assembly; you may need to remove the plastic cover or clip. Disconnect the electrical connector from the bulb, twist the bulb socket counterclockwise to remove it, and replace the old bulb with a new one, ensuring not to touch the glass part. Reconnect the electrical connector, secure the assembly, and close the hood.
How do you replace headlight bulb on 2004 Mazda Tribute?
The light assembly is secured with two Phillips (cross-head) screws. Remove the screws, then pry the light assembly from the car. Gently flex the sides of the bulb holder to free the bulb. Replace bulb. Push assembly back into place replace the two screws