To replace the accelerator linkage on an '86 Vanagon, first, ensure the vehicle is parked on a level surface and the engine is off. Remove the engine cover and locate the accelerator linkage, which is connected to the throttle body and the accelerator pedal. Detach the linkage by unbolting or unclipping it from both ends, then install the new linkage by reversing the removal process, making sure all connections are secure. Finally, test the pedal to ensure smooth operation before reassembling any removed components.
Here you go: http://www.vanagonparts.com/fuse_panel_86to91.html This covers 86' thru 91" VW Vanagon fuse boxes
check for vacuum leaks
72-86 Mercedes and 71-86 Volkswagen Transporter & Vanagon. Some new Audi's and new Vw Passat's and GTi's.
I have an 86 VW Vanagon and just installed 6x9s in that spot but be sure to use speaker covers so as not to damage the cones by kicking them while going in and out.
To replace the injectors in 86 Toyota truck 22r, simply refer to your user and service manual.
the transmission is smoked needs to be taken out and inspecked or there is a LINKAGE PROBLEM GOOD LUCK JOEY
To install an oil switch relay on an '86 VW Vanagon, first ensure the engine is off and the key is removed from the ignition. Locate the oil pressure switch, usually found near the oil filter, and disconnect the electrical connector. Connect the new relay according to the wiring diagram, typically involving connecting the relay to the oil pressure switch, battery, and starter, and then secure it in place. Finally, double-check all connections, reattach the electrical connector to the oil pressure switch, and test the system.
n=43. 2n=86 is the same as saying 2 of what is 86? or 2 x n = 86? (replace "of" with x and "is" with =) REad it like an equation. so, 2x43=86 and n=43
Get a hammer, and break it
Is it the 86 or 86.5?
Yes, but you must replace the blinker fluid prior to starting the replacement engine.
three hours