This question was asked and answered earlier, so please search for a more complete answer. You need to peel the liner from the trunk lid, reach in to access the bulbs. The bulbs are bayonet base type.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
Same circuit/fuse as the parking/tail lights.
To replace the license plate lights on a 2004 Ford Freestar, first, open the rear hatch. Locate the license plate light assembly, which is usually secured by a small screw or clips. Remove the assembly, disconnect the old bulb, and replace it with a new one. Finally, reattach the assembly and test the lights to ensure they are working properly.
To replace the license plate lights on a 2005 Ford Escape, first, open the rear hatch and locate the access panel for the license plate lights. Use a flathead screwdriver or a similar tool to gently pry off the cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and twist it clockwise to secure it. Finally, replace the cover and ensure the lights are functioning properly.
to wire the license plate lights you must have lights and wire them to the scooter.
there should be 2 screws above license plate, take the off piece pops off and replace lights
Possibly a bad ground in the rear wiring harness somewhere.
To replace the license plate lights in a 1995 Toyota 4Runner, first, locate the light fixture above the license plate. Use a flathead screwdriver to gently pry off the plastic cover of the light assembly. Remove the old bulb by twisting it counterclockwise and replace it with a new bulb, then reassemble the fixture by snapping the cover back in place. Finally, test the new lights to ensure they are functioning properly.
No, the license plate light is wired in with the rear tail lights, not the brake lights.
Oldsmobile stopped making Alero in 2004 and GM stopped making Oldsmobile in 2004, so some mistake here?
To replace the license plate lights on a 2005 Kia Sedona, start by opening the rear hatch and locating the license plate light assembly. Use a flathead screwdriver to gently pry off the light cover. Remove the old bulb by twisting it counterclockwise, then insert the new bulb and reassemble the cover. Finally, test the new lights to ensure they are working properly.
Open the trunk and look for the wires that connect to the license plate lights. You should see a plastic piece that hooks into a socket. Simply grab the plastic piece and turn and the lights should come right out. The lights may be behind a paneling.