what is cost to replace a clutch in a BMW Z3
The BMW z4 replaced the BMW z3 in late 2002. The BMW z3 was introduced in 1996 shortly after staring in a James Bond movie. Not as easy on the eyes as the z3 but just as nice.
Under the steering wheel panel
According to the haynes manual it is under the glovbox on the blower box but it isn't theres in a 1998 BMW z3 and i am trying to research the location
On the 1998 BMW Z3 1.9 engine, the camshaft position sensor A is located at the rear of the engine near the cylinder head, on the driver's side. It is typically mounted to the engine block and can be accessed from the top of the engine bay. To replace or inspect it, you may need to remove the engine cover for better access.
no
To replace the battery in a 1998 BMW Z3 key fob, first, locate the small slot or notch on the side of the fob. Use a flathead screwdriver or a similar tool to gently pry the fob open. Once opened, remove the old battery, typically a CR2016 or CR2025, and insert the new battery with the correct polarity. Finally, snap the fob back together securely.
How do you charge a 2002 BMW Z3 battery
To replace the ignition switch on a 1998 BMW Z3 Roadster, first disconnect the car battery to ensure safety. Remove the steering column cover by unscrewing the screws, then locate the ignition switch. Disconnect the wiring harness and remove the ignition switch by unscrewing it from its housing. Install the new ignition switch by reversing the steps, reconnect the wiring, and reattach the steering column cover before reconnecting the battery.
No, it's not in the seat, it's in the dashboard in front of the passenger.
Begin by removing the retaining ring at the top of your 1998 BMW ignition switch. The ignition switch will slide out. Remove the wiring harness.
the 328i BMW if it is the M52 engine should be using 5w30 synthetic oil, same as the 2.8 Z3