To replace the O2 sensor on a 1993 Volvo 240, first, locate the sensor, which is typically found on the exhaust manifold or downpipe. Disconnect the electrical connector and use an O2 sensor socket or wrench to unscrew the old sensor. Install the new sensor by threading it into the same location, tightening it securely, and then reconnecting the electrical connector. Finally, start the engine and check for any error codes or issues.
Which sensor ???
The engine temperature sensor on a 1993 Volvo 240 is typically located near the thermostat housing on the engine block. It is usually mounted in a threaded port and can be identified by its electrical connector. To access it, you may need to remove any covers or components obstructing the view. Always ensure the engine is cool before attempting to inspect or replace the sensor.
YES
I have a 240 and with the knock sensor unplugged it will still start so I would have to say no.
how can i repair a wirie taht has been broken from alternator to wiring harness on 1990 volvo 240?
If they're identical, yes. Try it and find out.
replace ign sw on 1991 volvo 240
1993 Volvo 240 WAGON 5spd manual transmission. there are two screws on iether side of the console. then its just a matter of disconnecting wires.
Inside the reservoir.
the 02 senser is on the manifold by the firewall on the passenger side under the hood [ behind and undr the spark plugs]
It can be a little expensive to replace the EGR valve on the 1987 Volvo 240 DL. The job takes about 1 to 3 hours and can cost as much as about 240 dollars.
met poep