to chang ethe brake bulb, first lift up the rear hatch of the car, look to see what brake light is out, the you nee to look on the inside of the tail light assembly and you will see 2 scews or bolts holding the assembly in place take out those bolts and pull out on the brake light. next you will then turn the middle connector half a turn till it unseats itself from the assembly then you can replace the bulb
The ABS computer has detected a malfuction and set a code.
The brake light switch on a 2004 Chrysler Pacifica is typically located above the brake pedal, mounted on the brake pedal assembly. It is usually positioned near the top of the pedal arm, where it can be activated when the pedal is pressed. To access it, you may need to remove some panels or trim under the dashboard. Always consult the vehicle's service manual for specific details and guidance.
Possibly the brake light switch is bad. I had a recall on a Ford Taurus that spoke of this problem. The brake light switch releases a solenoid that holds the shifter in park.
brake light switch is mounted by the brake pedel remove lower panel above brake pedel and then you will see the switch should be able to turn the switch to replace
Bulb is probably defective. Replace it.
In the top of the trunk near where the brake light is located, there is a small plastic window, remove it and you access the light bulb.
Behind the fog light and under the bumper, just rotate and the bulb assembly will pull out. Very easy.
Brake light, on your 2000 Chrysler Concorde, by accessing it from the inside of the trunk. Take hold of the brake light, push in and turn. The brake light will come out.
You can't
No, it is a brake light.
Center High Mount Stop Lamp or CHMSL. It is also called a third brake light.Center High Mount Stop Lamp or CHMSL. It is also called a third brake light.
next to the right side head light