0
What else can I help you with?
Can you replace a 125w mercury vapour lamp with a 80w without changing control gear?
No, you cannot replace a 125w mercury vapor lamp with an 80w lamp without changing the control gear. Control gear needs to match the wattage of the lamp to ensure proper operation and to avoid any damage or safety issues. It is essential to use the correct wattage lamp specified for the control gear being used.
How do you replace the stop lamp sensor on a 1993 Volvo 940?
check the switch on the top of the brake pedal.
How do you repair a broken turn signal lamp on a 1992 Volvo 740 Wagon?
You need to replace it. There are 2 screws that hold it on.
How do you replace a gear shift lamp on 2006 Toyota Corolla?
The gear shift lamp on a 2006 Toyota Corolla can be replaced by taking apart the gear shift plate and replacing the bulb. This can be a very complicated procedure. The top of the gear shift plate is held on by clips at the front and back.
How do I replace tail lamp 2003 Volvo v70?
To replace the tail lamp on a 2003 Volvo V70, first, open the rear hatch and locate the tail lamp assembly. Remove the screws or clips securing the assembly, then gently pull it out from the vehicle. Disconnect the electrical connector and replace the bulb or the entire assembly as needed. Reconnect the electrical connector, position the assembly back into place, and secure it with screws or clips before closing the hatch.
How do you replace stop light 1992 Volvo 940?
Which one, the middle one or one of the two outside ones and is it the whole lamp or just the bulb you want to replace?
How do you reset maint req light 2007 corolla?
MAINT REQD on means its time to replace your engine oil. The indicator lamp stays on until it is reset. To reset this reminder: While the ignition switch is on, but the engine is not running, move the trip selector to ODO. Push and hold down the trip selector push knob. Turn off the ignition switch, then turn on the switch. The reset will go through 000000.0 then ------, -----, ----, ---, --, -. once it runs through, release the trip selector knob. The MAINT REQD lamp goes out.
How do you replace interior door courtesy lamp?
How do you replace interior door courtesy lamp?
Wiring diagram for 1984 Volvo penta?
how i can know about lamp wiring... type of Volvo 1984 injection modul
How do you change a front fog lamp on a Volvo s60?
To change the front fog lamp on a Volvo S60, first, ensure the vehicle is turned off and parked on a level surface. Open the hood and locate the back of the fog lamp assembly behind the bumper. Disconnect the electrical connector, then twist and remove the fog lamp bulb holder. Replace the old bulb with a new one, reassemble the holder, reconnect the electrical connector, and test the light to ensure it's working correctly.
How do replace tail lamp bulb 2005 Xterra?
how to replace tail lamp 2005 xterra
How do you replace position lamp Volvo s60?
To replace the position lamp on a Volvo S60, first, ensure the vehicle is turned off and the keys are removed. Open the hood and locate the headlight assembly; you may need to remove a plastic cover or fasteners. Carefully twist and pull out the old bulb from its socket, then insert the new bulb, ensuring it is securely in place. Finally, test the new bulb to ensure it is functioning before reassembling any covers.
