for Renault laguna 2 hatchback/estate (2001-2007 model)
tools needed: screw driver with torx 20 and torx 40 heads, a ratchet with 13mm and 18mm sockets or 13mm and 18mm spanners, small flathead screw driver.
first you will need to de-activate airbag system you can do this by disconnecting the battery negative terminal (need 13mm socket/spanner to do so) and removing the airbag fuse 5A (which is located in the passenger fusebox) and then wait at least 10 minutes before continuing any work! (be very carefull since you will be working near airbag it can cause serious injury if you are not carefull!!!) if you still feeling confident then you will have to remove the bottom part of the rear seat, then using an 18mm socket/spanner remove the bolt with the seatbelt attached then pull down the back part of the seat, now you have to remove the C-pillar trim, to do this u will need a torx 20 screw driver remove the the only screw (on estate model the torx screw hidden under a square plastic cover), open the boot and remove the rubber seal around the C pillar from the boot and the rear passenger door, and then u just have to pull off the plastic cover which is being held by plastic clips (dont be afraid to use force, but do not use any screw drivers to pull it off!! you could damage the airbag) after the plastic cover is off pull the carpet away, u might have to make a tiny cut to have better access to the seatbelt tensioner remove the connector using a small flathead screwdriver, using torx 40 remove the 2 bolts holding the seatbelt tensioner and lift it out, congratulations you have removed the seatbelt!
refitting is the reversal of removing!
good luck!
how do you replace the rear springs on a renault espace
Lift them up!!!!
Yes, its the bit with 'garrett' stamped on it, rear right (from the front) of the engine.
Try opening a rear door then using the central locking button on the dashboard before exiting the car by the rear door
order new belts from an OEM supplier with new bolts and washers. remove rear seat and go to work!
The torque setting for the rear hub on a Renault Laguna typically ranges from 150 to 180 Nm (newton-meters). It's essential to consult the vehicle's service manual for the specific year and model, as torque specifications may vary. Always ensure the use of a calibrated torque wrench to achieve the correct settings for safety and performance.
To lift the rear seat of a Renault Laguna 2, locate the release mechanism, which is typically found at the base of the seat or on the side. Pull the lever or press the button to unlock the seat. Once released, you can lift the seat cushion upwards to access the storage space beneath or to remove it completely if needed. Ensure you secure it back in place after lifting or reassembling.
above the reg plate and where you open the boot there is a little black button press and the window will open
Starter is located to the rear of the engine,under the exhaust manifold.Three bolts attatch it the the gearbox,access to these is from above, in the engine bay.
To change the third brake light on a Renault Laguna, first, open the trunk and locate the access panel or cover at the rear of the vehicle, often found near the rear window. Remove any screws or clips securing the panel and gently pull it away to expose the light assembly. Disconnect the wiring harness from the old brake light, replace it with the new one, and reassemble the access panel by securing it back in place. Finally, test the new brake light to ensure it’s functioning properly.
You probably need new rear disc bearings. Once you install the new bearings, the warning light should turn off.
NO. The rear seat has 3 sets of belts.