To reprogram a 2004 ML350 keyless remote, start by sitting in the vehicle with all doors closed. Insert the key into the ignition and turn it to the "On" position (not starting the engine) and then back to "Off" five times within 10 seconds. After the fifth turn, leave the key in the "On" position, and the locks should cycle to indicate the vehicle is in programming mode. Finally, press any button on the remote to program it, and the locks will cycle again to confirm successful programming.
How do i you program keyless remote for a 2004 malibu?
Check the batteries in the remote with a volt meter.
To reprogram a 2004 Jeep Grand Cherokee keyless entry remote, insert the key into the ignition and turn it to the "On" position without starting the engine. Press and hold the "Unlock" button on the driver's door while simultaneously pressing the "Lock" button on the remote. Release both buttons, and then press the "Lock" button on the remote again. The locks should cycle to confirm successful programming; if not, repeat the steps.
how can i program a remote for a 04 kia spectra
The remote keyless entry module on the 2004 Kia Optima is located under the driver's side dash. To find it, open the door and look up under the dash.
try following instructions @ www.programyourremote.com
see also 2004 silverado
Possible weak battery in the remote.
My 2004 land rover discovery 2 doesnt work?
I found an Internet site which says how to program the keyless entry remote. But there is an error: this procedure is good for Elantra 2001 to 2003. Elantra 2004 must be programmed by the dealer. http://car.justanswer.com/hyundai/n1kw-program-remote-entry-hyundai-2004
i lost the ignition key anl keyless remote on my for f150 2004 truck
You have to program it with a DRB (Scan tool).