0
To reset the brake light on a 2003 BMW X5, first, ensure that the brake light bulb is functioning properly and replace it if necessary. Next, turn on the vehicle's ignition without starting the engine. Then, press the brake pedal firmly and hold it down for a few seconds. Finally, release the pedal and check if the brake light has been reset and is functioning correctly.
What else can I help you with?
How do you reset brake light for 2004 BMW 745?
how do you reset brake warning light 0n 745li bmw
How do you reset brake light on 2006 BMW 525i?
how can i reset rear brake pad warning light on 2006 bmw 525i
How do you reset an abs light on 1997 BMW 540i?
how do I reset tne brake pad sensor light on a 1997 BMW 318i
How do you reset BMW 525i 2007 brake light?
You will need a compatible BMW scan tool to reset this service light from the I drive system.
How do you reset service engine soon light on a 2003 325i BMW?
reset service engine light on BMW 325
How do you reset the oil service warning light manually on a 2003 BMW 525i?
How do you reset the oil service warning light manually on a 2003 BMW 525i?
When to service BMW x5?
Had brake linings replaced but brake light and check brake lining light will not go out how do I reset.
How do you reset brake fluid light BMW 2007 525i?
You will need a compatible BMW scan tool to reset this service light from the I drive system.
How do you reset the oil service light manually on a 2003 BMW 325XI?
How do you manually reset the oil life monitor on a BMW 525i
How do you reset brake pad light on BMW x3?
To reset the brake pad light on a BMW X3, start by turning on the ignition without starting the engine. Then, press the gas pedal three times while holding the brake pedal. After that, turn off the ignition and then start the engine; the brake pad light should be reset. If the light persists, it may indicate an issue that requires further inspection.
How do i reset brake warning lights on a 2003 BMW z4?
To reset the brake warning light on a 2003 BMW Z4, first, ensure that the brake fluid level is adequate and that the parking brake is fully released. Next, turn the ignition to the "On" position without starting the engine, then press the gas pedal three times within 10 seconds. Finally, turn off the ignition and restart the car to check if the warning light is off. If the light remains on, it may indicate a more serious issue that requires further diagnosis.
How do you reset brake light for 2003 BMW 745 IL?
if the 2 brake sensors are in the brake pads then the only thing you need to do is detach the neg. cable on the battery for about 10 seconds and then put it back on. That should do it. Dave w
