0
Push the check button on the active check control panel located above the rear view mirror. If the light does not go out then either the levels of oil and coolant are low or the sending units are failing. The oil level sending unit is located below the alternator and the coolant level sender is located toward the front of the overflow tank that is mounted in front of the drivers side strut tower. Many times these senders can be cleaned and they will begin to function normaly. You can test them with an ohm meter while you move the float up and down.
What else can I help you with?
How do you reset the coolant level warning on a BMW 525I?
Add more fluids
How do you reset low coolant light in a 2000 Silhouette?
To reset the low coolant light in a 2000 Silhouette, first ensure that the coolant level is topped off in the reservoir. Next, turn on the ignition without starting the engine, allowing the dashboard lights to illuminate. Once the low coolant light is on, press the gas pedal three times within five seconds to reset the warning light. Finally, start the engine to confirm the light has been reset.
How do you Reset dashboard warning lights on 90 Lexus ES250?
How do I Reset dashboard warning lights on 90 Lexus ES250
How do you reset a warning light on a Chevy Tahoe?
If the warning lights go off in a Chevy Tahoe, it indicates a problem. In order to reset these lights the problem must be solved.
How do you reset check coolant level in a 2001 Cadillac deville?
on info panel when warning shows just press reset on right side of instrument cluster amke sure your coolant tank is full if warning returns the sensor can be gummed up with engine sealent used by gm, replace sensoe or flush reserve tank with hose,drain it a fill with coolant
How do you reset warning lights on a Pontiac G6 GT?
Depends on what warning light you are asking about.
How do you reset flat tire warning on BMW 330?
on most vehicles you can reset warning lights by simply unconnected a battery cable
How do you reset warning lights 95 Oldsmobile?
The check engine and other dash warning lights can be reset by disconnecting the vehicles battery for more then 5 minutes. If warning light continues after reconnecting battery then there is still a problem.
How do you reset coolant warning light in 325i?
you may need to replace the sensor for the coolant, there should be a wire connected to it.
How do you reset warning lights on your dash?
To reset warning lights on your dashboard, first, address the underlying issue that triggered the light. Once resolved, turn off the vehicle and disconnect the battery for about 15 minutes, then reconnect it. Alternatively, you can use an OBD-II scanner to clear the codes associated with the warning lights. Finally, start the vehicle to check if the warning lights remain off.
How do you reset the low engine coolant warning light on a 2003 Saturn VUE?
fill the coolant reserve and the light should go out
How do you reset the warning lights on a 2005 Jeep Grand Cherokee?
To reset the warning lights on a 2005 Jeep Grand Cherokee, start by turning the ignition key to the "On" position without starting the engine. Then, press the gas pedal three times within ten seconds. After that, turn the ignition off and then restart the engine; the warning lights should be reset. If the lights remain on, it may indicate an underlying issue that needs to be addressed.
