answersLogoWhite

0

To reset the rollover bars on a 1998 BMW M3, start by ensuring the vehicle is on a flat surface and the ignition is off. Open the rear trunk and locate the rollover bar reset button, usually found near the rear seat area. Press and hold the button for a few seconds until the bars retract fully. After this, start the car to ensure the system is functioning properly.

User Avatar

AnswerBot

1w ago

What else can I help you with?

Related Questions

What is the purpose of roll bars?

The purpose of roll bars is to prevent a vehicle from rolling over. It contains a torsion spring bar that is also known as a sway bar to achieve this.


How do you reset a rollover warning light on a BMW?

Do not roll over your BMW and you will not have this issue.


What is a benefit of stabilizer bars?

Stabilizer bars are sometimes referred to as anti-sway or anti-roll bars. The purpose of the stabilizer bar is to keep the car from rolling over when it goes around a bend.


Why do Jeep Wranglers have roll bars?

because they roll easily...


What is the safety feature in cars called "roll bars"?

Roll bars are a safety feature in cars. Typically they are found in convertibles. They aid to protect the driver in the event of an accident and the car was to overturn.


What are the release dates for SeaScope - 1998 Taking Roll 1-36?

SeaScope - 1998 Taking Roll 1-36 was released on: USA: 1998


How do you complete level 17 in a hundred floors?

The seventeenth level has a glass door with silver bars across it, which is located on a red brick wall.Roll ball over right button, then left button. Roll ball over right button 2 times. Roll ball over left button 3 times. Roll ball over right button 2 times.See related link below for screenshots.


What are the release dates for Rock and Roll Classics - 1998 TV?

Rock and Roll Classics - 1998 TV was released on: USA: 2 March 1998 (premiere)


What are the release dates for Tricked Out - 2004 Honda S2000 Roll and Sway Bars 3-10?

Tricked Out - 2004 Honda S2000 Roll and Sway Bars 3-10 was released on: USA: 8 September 2006


How do you restore fuel pump operation flow after roll-over rollover upside-down upside down on a 96 grand Cherokee?

im not 100% sure but many cars have a reset switch at the roll over valve, i have no idea where it is on the car i can only guess its on the fuel pump


Can you swap a 91 wrangler rollbar to a 95?

Yes, the roll bars should be compatible.


Does Toyota MR2 has rollbar?

No factory roll bars were installed in any generation of MR2