Airbag light can only be reset using diagnostic equipment.
how do u reset service light on 2007 plate bravo
If you buy a Fiat, you don't way to visit the concesination hay que joderse.
To reset the oil service light on a Fiat Bravo, turn on the ignition without starting the engine. Press the accelerator pedal three times within 10 seconds. After doing this, turn off the ignition and then start the engine to ensure the oil service light has been reset. If the light remains on, repeat the process.
If the light is on, but the airbag hasn't deployed, it need reset by a diagnostics machine which can be found with some independent garages, or the Fiat main dealer. Indies are less expensive, but make sure that you tell them that you aren't paying for it if they can't reset it before letting them at it. If the airbag has deployed, it will need an new body computer as they are "1-shot" systems. If your still having problems, check out www.fiatforum.com
To reset the service light on a 2008 Fiat Bravo, first, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within 10 seconds, and then turn the ignition off. When you start the engine again, the service light should be reset. If the light persists, consult the owner's manual for further instructions or verify if additional maintenance is required.
Normally behind the passanger side glovebox A three pin connector
Only a FIAT dealer can do this.
The engine light is reset by disconnecting both cables from the battery (Negative first) for 5 minutes. When you reconnect the battery (positive first) Start the car, the computer is now reset and the light is off. If the engine light comes back on, take it to a mechanic in order to find out the trouble codes. Good luck
User manual (and my local FIAT garage) say this can only be done by a FIAT dealer
To reset the fuel cut-off switch on a Fiat Bravo, locate the switch, which is usually found in the boot or near the fuel tank. Press the switch firmly to reset it; you may hear a click indicating it has been activated. After resetting, check the vehicle's electrical system and ensure there are no underlying issues. Finally, attempt to start the engine to see if the reset was successful.
To switch off the service schedule light on a 2008 Fiat Bravo, you typically need to turn on the ignition without starting the engine. Then, press the gas pedal three times within 10 seconds. Finally, turn off the ignition and restart the engine to ensure the light has been reset. If the light persists, you may need to consult the vehicle's manual or a professional mechanic for further assistance.
To turn off the passenger airbag in a Fiat Bravo, locate the airbag switch, usually found on the side of the dashboard or in the glove compartment. Use the vehicle key or a similar tool to toggle the switch to the "off" position. Always consult your owner's manual for specific instructions and safety information related to your model year, as the location and method can vary. Remember to turn the airbag back on when a child seat is no longer in use.