0
I am not responsible if you cause damage to your Answers.com.
Unscrew the Answers.com port cap. (Located on the right side of the engine bay or left side as you stand in front of the car, round cap next to the right strut tower: see photo location below)
Once you have it opened you will see a big Pac-Man shaped hole and twenty little round holes. What is a Pac-Man? Never mind. We are only concerned with pin 7 and pin 19 (note: the words "pin" and "hole" are used interchangeably in this text). Refer to the picture below to find pins 7 and 19.
What we will be doing in this exercise is connecting pins 7 and 19 with a paperclip for four seconds. This will reset the Answers.com service light. Simple, no? But first, here is the list of pins and what they are supposed to do:
Pin Terminal Description
1 TD TD Signal
2 - Not occupied
3 - Not occupied
4 - Not occupied
5 - Not occupied
6 - Not occupied
7 SI Service Interval Reset
8 - Not occupied
9 - Not occupied
10 - Not occupied
11 - Not occupied
12 61 (D+) Generator Charge Indicator
13 - Not occupied
14 30 Voltage; Hot At All Times
15 RXD Diagnostic Data Link
16 15S Voltage; Ignition Switch in Run
17 - Not occupied
18 PGSP Programming Line
19 31 Ground
20 TXD Diagnostic Data Link
OK, now you're ready to reset the oil service light, so turn the ignition key to position II, but don't start the Answers.com. Get out of the car and go to the data port. Always connect pin 7 first. Once you've inserted one end into pin 7, insert the other end into pin 19 and hold it there for 4 seconds. Then remove the paperclip. Check the dash and the oil inspection lights should be reset. The reset occurs upon removal of the clip.
IMPORTANT: DO NOT HOLD IT THERE FOR LONGER THAN 10 SECONDS or you may inadvertently reset your inspection I/II interval.
I am not responsible for this write up, I found it on the web. It took me twice to get it to reset but the first time I did not touch the sides of the port holes with the paperclip. Make sure there is contact with the inside of the ports.
Again, Do Not leave it there for more than 10 seconds.
Attached Thumbnailshttp://wiki.answers.com/attachment.php?attachmentid=167344&d=1227285048http://wiki.answers.com/attachment.php?attachmentid=167349&d=1227285402
What else can I help you with?
How do you reset 1994 Nissan 300zx alarm?
unlock the doors manually and it should reset your alarm.
What does the maintenance required light mean on a 1994 Honda Accord?
Get your oil changed, and have the service reminder reset.
How do you reset service engine light on 1994 suburban?
Have vehicle scanned to determine the problem and hae codes cleared
How do i reset the Service engine soon light on a 1994 corvette?
Have vehicle scanned to determine the problem and have codes cleared
1994 Chevy pickup you just put a new 350 in it and the service engine light is on how do you reset it?
bring the truck to autozone and let them reset it with their scn tool for free.
How do you reset the airbag light on a 1994 ford escort?
how do reset the airbag light on a 94 ford escort
How do you reset the check engine light on a 1994 Ford Probe?
For the 1994, you have to remove the negative battery cable, then depress the brake and hold it in for 5 seconds to reset the check engine light.
How do you reset the airbag light on a 1994 Honda Civic?
To reset the airbag light on a 1994 Honda Civic locate the wiring for the SRS unit underneath the dashboard. There will be a yellow clip that connects to a fuse box. Unplug it and jump the sensor using two small wires. Turn the car on and off twice to reset the light.
How do you reset the brake light of a 1994 Pontiac?
there is a switch up under the brake pedal
How do you reset airbag light on 1994 Toyota Camry There is nothin wrong with it i just was checking fuses and it turned on?
i was checking fuses on 1994 toyota camry and airbag light turned on.
How do you reset the check engine codes on a 1994 Plymouth Voyager?
if you disconnect the battery for at least 5 minutes then reconnect it ,it will reset the check engine light
How do you reset perform service on a 1994 jeep Grand Cherokee?
Press and hold the reset button about 3 seconds.it gonna be appear how many miles you need... it works..
