Press and hold the service wrench button with the ignition off. While still holding the button, turn your ignition to "on" (but don't start the car). Press the Min clock button and then release the wrench button.
I found these steps work well:
1. Key in slot (no Accessory activated)
2. Hold "0.0"
3. Push key in to activate Accessories
4. Push "wrench" icon button
5. Release "0.0"
6. Start vehicle
Answer : to reset the display do the following : with the ignition switched off, press and hold the trip meter reset button below the speedometer. Switch the ignition on and hold the reset buttton for at least 10 seconds. Dashes appear in the display. The service has been reset.
drzis pritisnute desne obje tiphe i onda das kontakt pa stisnes ljevo min i to je to...
Turn key II position Press & hold Odomenter reset button until service light flashing. Press the reset button again for > 5 seconds The service oil life display will be reset to 100%
To reset the service indicator wrench:Hold down the odometer reset button with the ignition offWait for the trip indicator to show 0's. Then turn the ignition on, but don't start the carLet go of the reset button, and press the M button.
How do you reset maintenance service indicator on a 2006 Mercedes E350
To reset the service reminder on a 2006 VW Polo 1.6, first turn on the ignition without starting the engine. Press the trip reset button on the dashboard until the mileage display shows "Service." Then, hold the button down for about 10 seconds until the service indicator resets. Finally, turn off the ignition to complete the process.
On my 2006 55 plate Dynamic you toggle the computer to display the service details, hold the button in until it changes the screen to show when the next service is due.
How do I reset the Service A/B on a CLK 350
Turn the ignition switch to off, then press and hold the service wrench button. While still holding the button, turn your ignition to on without starting the car. Press the clock button marked "Min" and then release the wrench button.
To reset the oil mileage on a 2006 BMW Z4, turn on the ignition without starting the engine. Press the gas pedal three times within ten seconds to access the service menu. Then, use the trip odometer button to navigate to "Oil Service" and press and hold the button until the display shows "Reset." Confirm the reset, and the oil mileage indicator will be cleared.
The 2006 Passat doesn't have bluetooth.
When the car is off, hold the reset button on the right side of the dash (0.0). Then turn the key on (not the engine) and once the service now words come out on the display press the minute(m) button on the right. That should turn the service now off.