answersLogoWhite

0

To stop the antenna extension noise on a car radio, first ensure that the antenna is securely connected and not loose. You can apply some lubricating grease or a rubber washer to the antenna joint to minimize vibrations. Additionally, checking for any physical damage or wear on the antenna itself may help, as replacing a faulty antenna can also resolve noise issues. If the problem persists, consider adding a noise filter to the radio's power supply.

User Avatar

AnswerBot

3w ago

What else can I help you with?

Related Questions

What would be the best way to test for alternator whine noise?

This is noise coming from a source within the receiver - either the radio or cassette section (noise from a CD transport is very rare). If you determine that the noise originates with your radio antenna, an antenna filter (like American International's AS100) plugs in between the antenna and your receiver to stop (or minimize) noise from entering your system.


What would cause the radio and antenna to stop working on 2001 4runner?

The radio and antenna in a 2001 Toyota 4Runner may stop working due to several potential issues, such as a blown fuse, a malfunctioning radio unit, or a damaged antenna. Electrical problems, like frayed wiring or poor connections, can also impact functionality. Additionally, a faulty antenna motor or an obstruction could prevent the antenna from extending properly. Diagnosing the specific cause typically requires checking the fuse box, inspecting connections, and testing the radio unit.


Your stereo is on without a ground what is wrong?

The radio is grounding through the antenna connection. Unplug the antenna and see that it will stop. However you still need to hook up the ground 1st and the antenna last.


Why would the radio antenna on a 1992 Buick Le Sabre all of a sudden stop popping up?

its shy?


What does a spiral do on a car radio antenna?

Wind noise reduction and stability. When engineers first designed tall circular towers (such as industrial boiler flues for factories), they ran into a problem - wind currents whipping round the towers would create strange forces that shook the tower from side to side, undermining its structural integrity. They discovered that they could solve the problem by adding a spiral round the top of the tower. It breaks up the wind currents and balances them out. The same problem and solution has been found in some steel suspension wires on bridges. So, the spiral on a car antenna is there solely to reduce wind noise and stop the antenna vibrating. It has absolutely no effect on the antenna's ability to receive radio frequency signals.


How do you stop a high pitch humming noise from radio when truck is running in 2004 Chevy truck 1500?

humming noise is a bad ground to the radio. you may have a loose connection. connect a ground wire to frame of truck.


How do you stop engine buzzing noise coming through radio on 2000 Chevy Blazer?

engine noise coming thru the radio is caused by a bad ground somewhere so instead of chasing that you go to a car stereo shop and buy a noise filter that hooks up to the ground wire coming off the radio.


Is there a fuse or wire you can disconnect to stop the power antenna that will not stop running on an 1986 Buick LeSabre?

the antenna its self will have a connector you can unhook


Slogans to stop noise pollution?

stop noise become wise


What is the duration of Stop That Noise?

The duration of Stop That Noise is 420.0 seconds.


Why Radio stop working on 2006 VW Beetle?

The radio in a 2006 VW Beetle may stop working due to several issues, such as a blown fuse, a faulty wiring connection, or a defective radio unit itself. Additionally, problems with the vehicle's battery or alternator can affect the radio's performance. It's also possible that the antenna is damaged or disconnected, leading to poor reception. Troubleshooting these components can help identify the cause of the radio malfunction.


When was Noise Won't Stop created?

Noise Won't Stop was created in 2007.