To tighten the handbrake on a Citroën Picasso, first, locate the handbrake adjustment mechanism, usually found under the center console. Remove any necessary covers to access it, then turn the adjustment screw or nut clockwise to tighten the brake cable. Ensure the handbrake lever is in the "off" position while making adjustments. Finally, test the handbrake to ensure it holds the vehicle securely before reassembling any covers.
It's in the fusebox on the left hand side below the steering wheel
howe to change hand brake
I think you may be talking about the dashboard dimmer switches.
Remove the fuse board cover at the right hand side of the steering wheel, the switch is located behind the mass of cables, a quarter turn to the left will allow the switch to be removed.
Under the passenger's seat for a right-hand drive car, or under the driver's seat for a left-hand drive car.
change hand brake cable citreon relay
Were is the fuel shut of valve on a Citroen Piasso. Open the bonet and look on the left hand side on the top corner, there is a red push button switch. that is the fuel cutoff switch.
there is a small long bolt on the left side of the brake handle tighten the nut to adjust
If the rear brakes are out of adjustment,the hand brake will not work..
Depress computer button on end of right hand (Wiper) stalk several times until required data is displayed.
To tighten your bike hand brakes effectively, first locate the barrel adjuster on the brake lever. Turn it clockwise to tighten the brake cable. Test the brakes by squeezing the lever to ensure they engage properly. Repeat the process if needed until the brakes feel tight and responsive.
Take out spanner from the right hand rear floor compartment. Unscrew the bolt attaching the wheel from the inside of the boot.