all corsa`s have electric power steering
No
what is the torque settings on the big ends and conrods on the opel corsa 1.4 utility
No power steering was not in 1997 corsa. it came after 1999
The Opel Corsa Utility 1.4 2008 Model does not have Tappets but Hydraulic Lifters.
If it is a newer corsa (built in the last 12 years or so) if guessing you mean the alternator belt because it doesn't actually have a fan belt as the fan is driven by a electric motor. To tighten the alternator belt is very easy...Just loosen the two or three bolts holding it on (do not take them right out) pull the alternator so that the belt tightens and then tighten the bolts back up. You may need someone to hold the alternator and belt tight whilst you tighten the bolts back up. If the belt still continues to squeal after you have tightened it a couple of times it means the belt needs replacing.
Cylinder head bolts Torgue wrench settings: Stage 1 ................ 25 Nm (18 lbf ft) Stage 2................. Angle-tighten a further 60 degrees Stage 3................. Angle-tighten a further 60 degrees Stage 4................. Angle-tighten a further 60 degrees USE NEW BOLTS
To change the steering rack on a Vauxhall Corsa, start by lifting the vehicle and removing the front wheels for better access. Disconnect the steering column from the rack, remove the tie rod ends, and detach any mounting bolts holding the rack in place. After removing the old steering rack, install the new one by reversing the disassembly process, ensuring all connections are secure. Finally, refill the power steering fluid, check for leaks, and align the wheels if necessary.
2002 opel corsa 1.7 turbo diesel cylinderhead torque settings
yes electronic power steering EPC
The body control module (BCM) on a Corsa Utility is typically located under the dashboard on the driver's side, near the steering column. In some models, it may also be found behind the glove compartment or in the engine bay, depending on the specific year and configuration. It's advisable to consult the vehicle's service manual for the exact location and access instructions.
I would not recommend it. The bolts are stretched during the torque procedure.