underneath the centre console is a clamp in the clamp should be your 2 brake cables that control your handbrake ...you can tighten them there ...use spanner as is a squeeze to get a socket on
its normally mechnical so find the steel cable and find the nut on the cable of the parking brake "handbrake" and tighten
this you have to look in your hand book that you have in the car when you buy it
Remove handbrake gator and tighten exposed nut at the end of the handbrake.
On a Saxo, the handbrake can sometimes come loose and needs to be tightened. To do so, first turn the engine on and place your foot on the brake. Push in the handbrake button and then pull up on the handbrake until tension is felt. Repeat as needed.
Directly under the car, in line with the exhaust tubing. : )
Remove side covers on rear ashtray and lift out unit. The adjustment nut needs a 10mm spanner. Just about take up any slack when handbrake is off. Don't over tighten.
There is a screw on the hand brake handle inside the cabin. Just take off the leather that is covering your handbrake lever, and you will see it.
If the rear brakes are out of adjustment,the hand brake will not work..
Put the handbrake on and lift the rubber flap up just below the lever. Beneath that will be a 10mm nut, tighten that to adjust handbrake. 1993 micra should be about 5-7 clicks
To refix the handbrake on a 1999 VW Polo, start by removing the center console to access the handbrake mechanism. Check for any loose or damaged cables and ensure the adjustment nut is functioning correctly. Tighten or replace any worn components, then adjust the handbrake lever to the desired tension. Finally, reassemble the console and test the handbrake to ensure it holds the vehicle securely.
firing order is 1243 N reg 1.4 Clio