The cost of a catalytic converter for a Mark 2 Renault Scénic typically ranges from $150 to $600, depending on factors such as the brand, whether it's original equipment or aftermarket, and local labor costs for installation. Prices may vary based on the specific model year and engine type. It's advisable to check with local auto parts stores or online retailers for the most accurate pricing.
Its all in the lights! the mark 1 has smaller headlights with the indicators to the side.
Lincoln Mark 8s 96 and newer have 4 Oxygen sensors, two per bank of cylinders (Two on the drivers side, two on the passenger side) one before the catalytic converter and one after the catalytic converter.
Your looking around the £150 mark.
Below the firewall on both sides of the car, where the pipes go down from the headers.
The Lincoln Mark VIII typically has four oxygen sensors: two upstream (pre-catalytic converter) and two downstream (post-catalytic converter). These sensors help monitor the exhaust gases and ensure optimal engine performance and emissions control. However, it's always best to check the specific model year and engine configuration for any variations.
I just got two quotes. One was for $501.00 the other was $476.00. You can buy the same converter they will put on your car for about $225.00 but then they will mark it up when they install it to around $425.00 and charge you $75.00 to install it.
On a Renault Scenic 1.6L (X reg), the timing marks are typically located on the crankshaft and camshaft pulleys. You should find a mark on the crankshaft pulley aligned with a reference point on the engine block. The camshaft pulley will also have a timing mark that should align with a specific point on the cylinder head. It's essential to ensure these marks are properly aligned when replacing the timing belt to maintain engine timing.
The timing positions for the timing belt on an 8-valve Renault Scenic typically involve aligning the crankshaft and camshaft marks to ensure proper synchronization. The crankshaft should be set to the TDC (Top Dead Center) position, usually indicated by a mark on the pulley and the engine block. The camshaft sprocket should also have a specific mark that aligns with the cylinder head. It's crucial to consult the vehicle's service manual for precise alignment details, as they may vary by engine variant.
To align the headlights of a Renault Scenic 2, first park the vehicle on a level surface about 10-25 feet from a wall. Turn on the headlights and mark the center of each beam on the wall with tape. Adjust the vertical and horizontal screws on the back of each headlight until the beams align with the tape marks. Ensure that the cutoff is level and that the right side is slightly lower to avoid blinding oncoming drivers.
Buy it or use another converter
Hi there, you can purchase access to Renault wiring diagrams at www.infotech.Renault.com Regards, Mark.
Could be plugged catalytic converter