Could be a bad fuel pump, clogged fuel filter or something in the electrical system is getting overheated like a coil or crankshaft sensor.
On top ov t engine you wil c t coil packs normally light grey or brown tops,remove them with a ten ml socket then pul them up and change.under them you wil c the spark plugs.aparently this is a coman fault in meganes.recomend 4 new coilpacks and spark plugs
The coil springs are not easy to remove or install. The spring needs to be compressed in order to be removed. It takes several hundred pounds of pressure to compress the spring.
We're on our second (and last) scenic - the first one was a petrol engine & blew at least one coil every other month... one of the reasons we went for a diesel engine on the current one - but have had a host of other problems instead.
Hi, This light came on in my Megane Scenic and it meant I had to replace one ( could be more ) of my coil packs on top of the manifold. Your car will lose power when in higher gear or going uphill.
The ignition coil is inside the ignition distributor.
there are 4 coils each coil is mounted on top of the sparkplug,it plugs onto the top of each individual sparkplug, there is a connection at the top of the coil which must be unpluged first,then coil is pulled upwards.perhaps only one needs to be replaced but which one?i had a coil problem before,the engine did not run smoothly and the emmissions warning light came on. i rang the Renault dealer,explained the symptom,the receptionist told me the problem was with the coils,i called over they had it fixed in less than 10 minutes
No. The coil provides the spark and the module tells the coil when to spark.
ignition switch The TDC Sensor is probably dirty, remove it and give the tip a clean, also the connecter.
The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
1999 Alero how do i test ignition coil pack