0
What else can I help you with?
Will 5-114 fit on a slk230 Mercedes?
Yes
What type superscharger is in a 2003 Mercedes-Benz SLK230?
The M111.974 engine fitted to the 2003 R170 Mercedes-Benz SLK230 uses the Eaton M45 Roots-type supercharger.
How do you remove the headlamp assembly from a 2000 Mercedes slk230?
To remove the headlamp assembly from a 2000 Mercedes SLK230, first disconnect the battery to ensure safety. Open the hood and locate the retaining screws or bolts securing the headlamp assembly, typically found at the top and side. Remove these fasteners, then gently pull the headlamp assembly forward to detach it from the vehicle. Finally, disconnect the wiring harness from the back of the assembly before fully removing it.
How do you remove the tension idler for the drive belt on a 2001 Mercedes slk230?
To remove the tension idler for the drive belt on a 2001 Mercedes SLK230, first ensure the engine is off and has cooled down. Locate the tensioner pulley and use a socket wrench to rotate the tensioner arm counterclockwise, which will relieve tension on the belt. Once the belt is loose, you can unbolt the tension idler from its mounting point and carefully remove it from the engine. Be sure to note the orientation for reinstallation.
What is the difference bewtween Mercedes slk320 and Mercedes slk230?
The SLK230 Kompressor has a 2.3 L (2295 cc) 197 hp I4 supercharged engine.The SLK320 has a 3.2 L (3199 cc) 218 hp V6 engine.
How do you fix a Mercedes Benz slk230 with the code U3FFF and the code PO700 appearing?
u3fff
How do you read the special 2000 slk230 Mercedes dipstick?
To read the dipstick on a 2000 SLK230 Mercedes, first ensure the engine is warm and turned off. Remove the dipstick, wipe it clean with a lint-free cloth, then reinsert it fully and remove it again to check the oil level. The oil level should be between the two marks or notches on the dipstick. If it’s below the minimum mark, add the appropriate oil type as specified in the owner’s manual.
Where is the signal flasher on a1998 Mercedes-Benz slk230?
On a 1998 Mercedes-Benz SLK230, the signal flasher is typically located under the dashboard, near the steering column. You may need to remove some paneling to access it. The flasher is often found in a relay box or as a standalone unit, and it can usually be identified by its cylindrical shape. Always consult the vehicle’s manual for specific details and diagrams for accurate identification.
How can you manually lower a convertible top slk230?
To manually lower the convertible top of a Mercedes-Benz SLK230, first ensure the vehicle is stationary and the ignition is on. Locate the manual release handle, usually found near the rear of the passenger compartment; pull this handle to disengage the top. Then, gently lift the top and fold it down into the storage compartment, ensuring it locks into place. Always refer to your owner’s manual for specific instructions regarding your model.
Where is switch to open gas cap on a 97 slk230 kompressor Mercedes?
There is no separate switch. It is unlocked when the car is unlocked.
Power lock does not work in 1998 Mercedes Benz slk230?
Check the fuse, if power lock fuse is burnt, replace it.
How do you remove windscreen from your slk230?
To remove the windscreen from a Mercedes-Benz SLK230, first, ensure the vehicle is on a stable surface and the battery is disconnected for safety. Carefully detach any trim or moulding around the windscreen, then remove the screws or bolts securing it in place. Use a windscreen removal tool or a fine wire to cut through the adhesive holding the glass, and gently push the glass out from the frame. Always consider consulting a professional if you're unsure about the process to avoid damage.
