answersLogoWhite

0

Jack it up, remove the wheel, pry off the center cap, remove the cotter pin and nut, then pull the bearings out with the hub. Note that some trailer bearings are sealed and replaced as an entire unit.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How does a person grease the bearings of a 1984 mallard travel trailer?

The bearings of a 1984 Mallard travel trailer can be greased by jacking up the trailer and removing the wheel hubs to access the wheel bearings. Pack the bearings with the proper grease and replace the wheel hubs and tires.


How do you repair the wheel bearings on a 1995 blazer yourself?

In most cases wheel bearings cannot be repaired and must be replaced. Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearings. Reverse the process to install the new wheel bearings.


How do you change the front bearings on a 2001 S10 4 wheel drive?

Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearings.


Who do you replace rear wheel bearings on 1996 tercel?

Remove the tire and wheel from your 1996 Toyota Tercel. Remove the end of the axle. Remove the wheel bearing seal. Remove the wheel bearing nut. Remove the wheel bearing. Reverse the process to install your new wheel bearings.


How do you change rear wheel bearings on 1978 Corvette?

How to remove rear wheel bearings on a 1978 corvette..?


How often do you lube wheel bearings in a utility trailer?

lube the whell bearings once a year is usually all that is needed


How do you change 2003 Kia Sedona rear wheel bearings?

Remove the tire and wheel from your 2003 Kia. Remove the axle end. Remove the wheel bearing retaining nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new wheel bearings.


How do I properly repack the wheel bearings on a bike?

To properly repack the wheel bearings on a bike, first remove the wheel from the bike. Then, take off the axle and remove the bearings. Clean the bearings and inspect them for wear. Apply fresh grease to the bearings and reassemble them in the wheel hub. Finally, reinstall the axle and adjust the bearings to the correct tightness before putting the wheel back on the bike.


How do you remove the bearings on a skateboard?

pop them out of the wheel


How do you repack boat trailer bearings?

To repack boat trailer bearings, first, remove the wheel and brake drum or hub to access the bearings. Clean the bearings thoroughly with solvent to remove old grease, then inspect them for wear. Apply a generous amount of fresh marine-grade grease to the bearings, either by hand or using a bearing packer, ensuring it is evenly distributed. Reassemble the hub, tightening it according to the manufacturer's specifications, and ensure the seals are properly seated to prevent water intrusion.


How do you remove rear wheel bearings on a Chevy Cavalier?

Remove the tire and wheel from your Chevy Cavalier. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing.


How do you replace wheel bearings front wheel bearings on a 2005 sunfire?

they are replaced as hub assemblies, remove the wheel, remove the caliper and rotor three bolts for the hub, axle nut, abs harness if the car has it, and remove the hub assy