Buy a new plastic hinge Volvo part number 31265160. To replace the hinge, push the two center pins through using a punch. This will free up the broken hinge and you can remove it. Attach the new hinge to the door, then set the grommets into the openings and push the pins in to retain the grommet. BE CAREFUL NOT TO PUSH THE PINS TOO FAR. All they need to be is flush with the grommet.
To replace the gas door on a 2002 Chevy Trailblazer, first, remove the broken or damaged gas door by gently prying it off its hinge or undoing any clips holding it in place. Next, align the new gas door with the hinge and press it into place until it clicks securely. Ensure that it opens and closes smoothly. If necessary, check the spring mechanism to ensure proper functionality before finishing the installation.
No. A stuck gas door is however.
Volvo's fuel door hinge is secured to the body by four expanding rivets allowing blind installation and removal (that is to say, without requiring access to the inside of the quarter panel.) Remove the old hinge by punching out the four rivet expander pins with a long, slender punch. (The approximately 1/8" expander pins aren't easy to see as they've been driven flush with the crescent-shaped hinge. The outside two are centered about 1/4" from each end of the hinge, with two more each about 1-1/4" inboard of those, centered in the spring holders.) DANGER--DON'T use an electric drill to drill out the pins as the close proximity to the fuel filler makes this an EXTREMELY DANGEROUS risk!!! Once the old hinge is removed, carefully assemble the hinge, door, and spring BEFORE securing to the car body. Clean the area of the fuel filler and remedy any rust. With the fuel door open on the hinge, line up the hinge's rivets with their respective holes and press the hinge in place with the rivet gaskets bottomed out on the sheet metal. While a helper holds the fuel door-hinge-spring assembly firmly in place, use a 1/4" drift and hammer to carefully sink the four rivet expanders flush to the hinge. Test the security of the rivets and carefully open and close the door to check alignment and flush fit of the door to the body.
Gas door is on the deck lid.
To put the door back on a DCS gas oven, first ensure you have the door at a 45-degree angle. Align the hinges on the door with the hinge slots on the oven body. Gently lift the door and slide the hinges into the slots, then lower the door to its closed position. Finally, check that the door opens and closes smoothly, ensuring it is securely attached.
The gas cap door release for the Volvo S80 is typically located inside the vehicle, on the driver's side. Look for a lever or button near the floor, to the left of the driver's seat, or sometimes on the dashboard. Pulling this lever or pressing the button will unlock the gas cap door, allowing you to access the fuel filler. If you're having trouble locating it, consult your owner's manual for specific details.
10 gas filters fitted in 95 Volvo
The 2001 Volvo C70 is a gas-powered vehicle.
The 2008 Volvo XC90 is a gas-powered vehicle.
The 2013 Volvo XC60 is a gas-powered vehicle.
The 2006 Volvo XC90 is a gas-powered vehicle.