Here's how I did it. The manual says to just slide back the yellow light cover, from the front toward the rear of the car, and that it will then pop out. Well, that's BS. It won't slide back, as one would expect. I used a shoehorn or something similar such as a small plastic putty knife. (You can use a soft cloth or towel to protect the edge of the bumper). I wedged the shoehorn/putty knife between the front edge of the light cover and the cut-out in which the cover sits. Then I gently pried that front edge up and back until it popped out. To replace it, pop it back in. That part is pretty straighforward. Hope this helps.
The parking release lever of C240 looks like ratchet.
The parts number A1402701365 for a Mercedes C240 is for the parking lever.
To replace front parking light on a 1999 Ford Taurus, lift the hood and remove the bolt holding the parking light housing cover. Twist the parking light off and replace with a new one.
To replace the parking light bulbs, remove the screw on top of the headlight and pop out the clearance light. The parking light bulb will be accessible after this removal.
you take the old bulb out and put in the other
you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light. you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light.
Remove the headlight assembly and you will have access to the parking light bulb.
Front or back?
To replace the parking light on a Vectra you need to lift the relay box which rests between the battery and light. Then, pull the three pin bulb out and put a new one in its place.
Air Distributor footwell, parking brake area
Mercedes Benz A 1402701365 Parking Release Lever
howto change 2007 kia spectra parking light