To replace the parking light bulbs, remove the screw on top of the headlight and pop out the clearance light. The parking light bulb will be accessible after this removal.
Yes you can just replace the headlight bulbs. First you have to take out the cover by the battery. Then unscrew the cover by the radiator and simply lift it up to take it off. The light bulbs are visible at this time.
To access the bulbs, you need to remove the fender well liner and the nut and disconnect the electrical connector.
no you do not
Yes, the 1990 Lexus LS400 is equipped with changeable headlight bulbs. The process involves accessing the headlight assembly, usually by removing a cover or component to reach the bulb. It's recommended to refer to the owner's manual for specific instructions and bulb specifications to ensure proper replacement.
email me and I will send you a pdf on how to change the body tailight bulbs. vbdenny
the plastic shield that covers the bulbs has screws that you can access with no trouble at all.
Changing any bulb on a Lexus is a challenge. The most difficult part is determining the exact process. The first time might take 2 hours while the second 20 minutes or less. While I have changed the headlight bulbs on my 90 LS400, I haven't on a ES300. My suggestion is to go to lexusownersclub.com and post a question in the ES300/330 forum. Someone there will know and help you as it is the best Lexus forum available. You might also try lextreme.com as he is alos really good. VBDENNY
The bulbs are replaceable behind the lens, so the lens (two screws for the front and 4 for the back) must be removed to change the bulbs.
If you only need bulbs then your solution is easy, however if the needles themselves no longer illuminate, then there is no bulb to replace since the needles are the bulbs. Your local Lexus dealer will be happy to assist you in this matter, there is one catch...they will only sell you the entire instrument panel. The last quote I got was around $300.00.
To replace the center console light bulbs in a Lexus IS300, first, ensure the vehicle is turned off and remove the center console trim by carefully prying it up with a trim tool. Next, locate the light bulbs, usually accessed by removing the gear shift surround or the console panel. Gently twist or pull out the old bulbs and replace them with new ones, ensuring they are securely in place. Finally, reassemble the console and trim, making sure everything snaps back into position.
Should be a common circuit with parking/tailightsRemove the bulbs from the parking and tailightsCheck sockets for corrosion/bare wiresInstall fuse and replace bulbs one a time to see if problem is in the exterior of vehicle - if not same procedure under dash board
Along the rear of the inside of the trunk there are four small bolts which need to be removed. Once removed, you will be able to push out the outer plastic cover holdind the light bulbs and wiring. From there, you can easily remove and replace the bulbs.