0
What else can I help you with?
Does voltage on ground mean open ground?
Voltage on ground can mean an open ground. It can also mean (high) current on ground, due to a ground fault such as reversed neutral and ground.
Why would a 2001 Ford Escape XLS be hard to start when it rains?
try replacing your spark plug wires, as they get old damp conditions will allow the spark to "ground out" sending your voltage back to ground instead of to your spark plugs where it belongs. good luck
Should there be voltage between the neutral and ground?
No, ideally there should be no voltage between the neutral and ground wires in an electrical system.
What are the 3 wires on a map sensor for a 5.7 hemi?
5 volt supply, sensor ground and signal voltage.5 volt supply, sensor ground and signal voltage.
What are the differences between voltage and potential difference?
Voltage is the potential difference to the ground. By convention, ground potential is zero volt.The above answer is incorrect. 'Voltage', by definition, is potential difference. It has nothing to do with being measured with respect to ground -in fact potential difference (voltage) cannot be measured with respect to anything.
What is the significance of the neutral to ground voltage in electrical systems?
The neutral to ground voltage in electrical systems is important because it helps to ensure the safety of the system. When the neutral to ground voltage is at the correct level, it means that there is a proper connection between the neutral and ground wires, which helps to prevent electrical shocks and fires. Monitoring and maintaining the neutral to ground voltage is crucial for the overall safety and functionality of an electrical system.
What is the voltage to ground of 13800 volts line to line?
On a three phase system with a line to line voltage of 13800, a wye connection will give you a voltage of, 13800/1.73 = 7977 volts to ground.
Phase to ground voltage?
There is such a thing, what is your question?
Why neutral ground voltage is 120v sometime 0v?
There should be no voltage on the neutral wire to ground. This is a serious situation. Call a qualified electrician to check this out.
Why do you have voltage to ground but not voltage phase to phase?
There is phase to phase voltage in 3 phase system.AnswerYou don't get voltage 'phase-to-phase'; it's 'line-to-line'!
If you measure positive voltage to ground will the meter show -12 volts?
No, if you measure positive voltage to ground, the meter will show a positive voltage reading. In this case, the meter will indicate the positive voltage difference between the measured point and ground, not a negative voltage value.
What cause excessive ripple voltage from a power supply.?
I think the cause of ripple voltage would be from a bad ground or capacitve voltage.
