answersLogoWhite

0

there should be a thin guard usually stainless steel that fits over the guides for lining up the tranny. between engine and transmission.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Is there a spacer between the harmonic balancer and the engine?

No.


Where is the spacer plate on a 99 ford explorer?

between torque converter and engine


Why does the Mercedes w109 6.3 have a spacer between the sub-frame mounting and body but the 280SE W108 does not?

the spacer lowers the front axle to alow to install the large m100 6.3 engine.


Can you put a throttle body spacer on tbi engine?

Yes, you can. TBI stands for Throttle Body Injection, and a spacer can be used provided you have the clearance for it.


Does a 1993 voyager 2.5 liter engine starter need a spacer?

No.


Is there a spacer in between the fly wheel and starter?

I think it's depending on the vehicle, there may be a spacer between the starter and the motor. There may be a shield between the starter and the transmission housing if your starter is bolted to the transmission.


How does a throttle body spacer works?

Throttle body spacer works by regulating the flow of air into the engine of the vehicle. It allows more air than is required into the system so that the engine does not have to work too hard to correct the combustion chamber.


Where is egr valve located on 1976 ford 351 engine?

On my 1977 Ford 302 engine it was mounted on the back of a spacer between the carburetor and the intake manifold - underneath the air filter - I don't know if yours is the same


Why broken spacer on Briggs engine output shaft?

If you are referring to the spacer between the end of the shaft and the blade then it broke because the unit struck something and the spacer (also referred to as the blade adapter) broke saving damage to the engine itself. This is a normal occurrence and can be replaced. Check the blade for damage or bending as this will cause the mower to run off balance causing greater damage. Also, I have seen the blade adapter break as well as the flywheel key keeping the unit from starting.


What makes a new starter make a sreeching noise when being started?

Probably a missing spacer between starter and engine block,may have fallen out during change over


What is a spacer?

A spacer is a tiny little blue thing, that they put in between your teeth, to give room for the braces. THey do hurt for the first couple of days. But you'll be fine.!


Where can you buy a spacer?

Where can you buy a spacer