answersLogoWhite

0

If you want to reset the light just remove the positive cable from battery for 5 min and reinstal this puts puter in reset mode.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Where is low air pressure warning switch located on 98 pete?

The low air pressure warning switch on a 1998 Peterbilt truck is typically located on the air manifold near the firewall on the driver's side of the vehicle. It is usually attached to the air system components and can be identified by its electrical wiring connector. You may need to consult the vehicle's service manual for specific instructions on locating and servicing the switch.


To switch off the service engine warning light?

unplug your car battery


How do you replace the ac switch in the dash of a 2002 beetle?

how do you replace the ac switch in the dash of a beetle 1999


How do you remove new beetle ignition switch?

the question is, how don't you remove new beetle ignition switch?


How do you turn on the fog lights for 2002 vw beetle beetle is there a switch somewhere?

Pull out on the headlight switch to turn on the fog lights.


Where is the fog lamp switch on your new beetle?

Pull out on the headlight switch.


Where is the clutch switch located on a 1970 vw bug?

There is no 'clutch switch' on a Beetle.


How do you reset service warning light on 1998 vauxhall astra?

hold milage reset button in and switch on ignition.hold for about 5 seconds and it will reset.


Why did the service 4x4 light come on in my 2000 Z71 does it have a problem or just need routine servicing on the 4x4 unit?

you need to have it checked. i have an 03 and there was a TSB regarding a faulty switch. it may be as simple as that.


Where is the switch to adjust side view mirrors on 2000 beetle?

On what?


Where is the turning signal switch on an '01 VW beetle?

The actual electrical switch is inside the steering column.


Where is the low beam button 0r switch for a 73 vw beetle?

The 1973 VW Beetle low beam switch can be found on the drivers side floorboard. The low beam switch will be all the way to the left of the drivers side floor.