The "Wrench" symbol will appear in the odometer field to indicate it is time to service the vehicle. To reset, turn the ignition key to position 2. Immediately press the button next to the display twice within one second. The present status for days or distance will be displayed. Within 10 seconds, turn the ignition key to the 0 position. Press and hold the button while turning the key to position 2 again. The status for days or distance will be displayed again; continue to hold the button. After 10 seconds, a signal will sound and the display will show 10,000 miles (15,000 km). Release the button. The "Wrench" symbol will appear in the odometer field to indicate it is time to service the vehicle. To reset, turn the ignition key to position 2. Immediately press the button next to the display twice within one second. The present status for days or distance will be displayed. Within 10 seconds, turn the ignition key to the 0 position. Press and hold the button while turning the key to position 2 again. The status for days or distance will be displayed again; continue to hold the button. After 10 seconds, a signal will sound and the display will show 10,000 miles (15,000 km). Release the button.
It's done with a code reader plugged into diagnostic port under dash.
I don't see why it wouldn't be.
You need a scanner. Very expensive. go to auto dealer and have them reset.
Hiw do you reset a service light j2
reset service engine light
How do you reset service light in 2003honda pilot
To reset the service light on a Mercedes-Benz M Class, disconnect the positive cable on the battery for a few minutes. If this does not do the trick, turn the key on and pump the gas three times then turn the key off. Start the vehicle. The light should be off.
how do you reset service d light on mercedes gl450
How do you reset 2008 honda element service light?
how do u reset service light on 2007 plate bravo
service it !!!
You need JCB service master to reset the service light on loadalls