answersLogoWhite

0

Hold trip button in,watch message center to see brake lining indicator light comes on,release button,push button on turn signal lever in,reset message appears,push same button once more (hold it there till the hour icon disapears).Done.Hope this helps.

10inja

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you reset oil light on 1989 BMW 325i?

Reset inspection light on 1989 bmw 325i


How do you reset the brake sensor light for a 325i BMW?

The brake pad sensor light is reset by leaving the key on engine off for about 20sec. If it does not reset retry, if it still does not reset check the wiring of the left front and right rear pad sensors


How do you reset disc brake warning light on 2004 325i?

To reset the disc brake warning light on a 2004 BMW 325i, you typically need to use a diagnostic tool or follow a manual reset procedure. If you have a diagnostic scanner, connect it to the OBD-II port and clear the fault codes. Alternatively, you can turn the ignition to the "on" position without starting the engine, then press the brake pedal three times. If the light persists, ensure that the brake pads are properly installed and that the brake fluid level is adequate.


How do you reset warning light for brakes BMW 2005 325ci?

The brake warning light on a 2005 BMW 325i can be reset by connecting an OBD II code reader. It can view and clear error codes detected by the computer.


How do you reset service engine soon light on a 2003 325i BMW?

reset service engine light on BMW 325


I have a 1995 BMW 325i and I'm getting a brake light circuit message on my display panel. What does that mean?

If it says 'Brake Light Failure' or similar, your brake light is out. change the bulb.


How do you reset low tire pressure light on a bmw 325i 2006?

depneding on model/yr, either thru console mounted button, or thru turn signal stalk


1990 325i cabriolet- brake light warning comes on all the time but lights check ok?

fault brake light switch, located at the top of the brake pedal.


How do you reset engine check light on 1995 BMW 325i?

You need a scan tool to plug into OBD port


How do you reset coolant warning light in 325i?

you may need to replace the sensor for the coolant, there should be a wire connected to it.


Can you jump a 325i BMW?

I have a 2006 325i and i have jumped it.


I have a 2006 BMW 325i and recently had a flat and had to get new tires but the low tire pressure light is still on. Is there a way to reset it?

Check the car manual, it has all the stetps. On i-drive veicles go to menu settings- info- reset TPM (tire pressure managment)