To set the timing on a Volvo 240, first, ensure the engine is at operating temperature and then turn off the engine. Locate the timing mark on the crankshaft pulley and the timing pointer on the engine block. Start the engine and use a timing light to check the timing; adjust the distributor as necessary to align the timing mark with the specified degree (usually 12-16 degrees BTDC for the B230F engine). Finally, tighten the distributor hold-down bolt and recheck the timing to ensure it remains accurate.
how do adjust timing belt on a volvo 240 DL ?
From Spokane Volvo Jag and Land Rover......the initial timing is 10 to 12 degrees!
To adjust the timing on a 1993 Volvo 240, first, ensure the engine is at operating temperature and then turn off the ignition. Locate the timing marks on the crankshaft pulley and the timing cover, and use a timing light to check the current timing. If adjustment is needed, loosen the distributor hold-down bolt and rotate the distributor slightly to advance or retard the timing as necessary. Once adjusted, re-tighten the bolt and recheck the timing to ensure it's within the specified range.
For the 1987 Volvo 240 DL, when aligning the timing gear marks, ensure the crankshaft is at TDC (top dead center) on the compression stroke. The timing mark on the crankshaft pulley should align with the mark on the timing cover. The camshaft gear should have its mark aligned with the mark on the cylinder head. Double-check that the distributor rotor is pointing towards the correct cylinder for proper ignition timing.
long answer: yes
Adjust ignition timing. check knock sensor.
Yes the 240 does have fuses. Was that your ?.
Depends on the motor. According to the Engish Haynes manual. B21 and B23 will not, B230 will.
To reset the timing on a Volvo 240 DL wagon, first ensure the engine is at top dead center (TDC) on the compression stroke for cylinder one. Then, locate the timing marks on the crankshaft and camshaft pulleys, aligning them according to the specifications in your service manual. Adjust the distributor to align the rotor with the correct spark plug wire terminal, and finally, tighten the distributor hold-down bolt to secure it in place. Always recheck the timing with a timing light after adjustments.
how do you reset engine light on 1991 volvo 240
To change the belts on a Volvo 240 DL, first, ensure the engine is off and cool. Locate the tensioner for the drive belt and loosen it using a wrench, then remove the old belt. For the timing belt, you'll need to remove the timing cover and align the timing marks before replacing it. Finally, install the new belts, ensuring they are properly aligned and tensioned, then reassemble any removed components.
About every 60,000 miles, depending on driving conditions.