0
I had recently a similar problem and it turned out to be the brake light switch. This mechanism controls and prevents shifting out of parking without depressing brake pedal. Please check if the brake lights go on when you depress the brake pedal, if not and the bulbs are not burnt out it is most probably this switch. The switch is located just above the brake pedal, it is tricky to get to it as you may have to feel it running along the brake pedal shaft. In order to replace you must disconnect hardware switch and carefully rotate the switch out. The part itself is bought from your local Land Rover dealer should not be more than $60 USD, conversely you could buy a replacement at Autozone or your local parts distributor. Personally I'd recommend original. To install you must depress brake pedal and turn it into place, then connect harness.
Good Luck
newtest3
What else can I help you with?
Where is the overdrive switch in a 2001 Hyundai Accent located?
on the gear shifter
Do you run your 2002 land rover discovery in high or low gear?
I run in Hi gear
My 2004 land rover Discovery is stuck in neutral?
Check to see if Brake lamps work when brake pedal is pressed. If not gear shifter is locked for safety so replace fuse or repair brake lamp switch.
Toyota Echo 2001 loose gear shifter cannot shift gears?
Not really describing answer , but i would assume you shifter cables have broken
1993 land rover discovery stuck in low ratio gear?
If a 1993 Land Rover Discovery is stuck in a low ratio gear, check the transmission fluid levels. If the fluid levels check out okay, the transmission may be experiencing a jammed gear.
How do you get a Land Rover Freelander 03 out of gear?
For most newer model cars you need the key to change the gear.
How do you put 2001 land rover discovery into high gear?
Move the car at a walking pace, put the gearbox into neutral and move the high/ low stick from low to high.
What car did Top Gear take up benn nevis?
land rover discovery
What type of fluid for differentials on 97 land rover?
80/90w gear oil
What is the inside of a gear shifter for a 2004 Lincoln aviator called?
shifter rod gear linkage
How do I replace the gear shifter on my bike?
To replace the gear shifter on your bike, follow these steps: Begin by removing the old gear shifter by loosening the bolt or screw that holds it in place. Slide off the old gear shifter and disconnect any cables attached to it. Install the new gear shifter by sliding it onto the handlebar and reattaching any cables. Tighten the bolt or screw to secure the new gear shifter in place. Test the new gear shifter to ensure it is functioning properly before riding your bike.
Your Dodge Intrepid shifter cable problems The gear shifter just goes up and dowm without going into gear. What can i do to make it go into gear?
your shifter linkage is probably broken.
