there is no speedo cable so if your speedo isn't working you either have a faulty sending unit or the dash half of it is bad
its electric from 1995
The speedometer on a Peugeot 306 diesel is typically driven by a simple mechanical cable rather than an electronic system. This cable connects the speedometer to the vehicle's transmission, allowing it to measure speed based on the rotation of the wheels. However, some later models may feature electronic speed sensors, so it's important to verify the specific model year for accurate information.
Replace the speedo head assembly. It is a sealed unit, with no servicable parts. If the speedometer is working, then the cable and the speedo drive gears are working. The failure must be inside of the speedo head assembly itself.
The logical problem - would be a broken speedo cable. The speedo & odometer are both run from the same cable.
hya i had the same problem with mine one day it was working then while driving it just went off if the speedo is electrics ratha than speedo cable then it is the speedo sensor that bolts into the gearbox it should have a connector up from the sensor cable (blue cable) unclip it from there and unbolt i bought sensor from local scrapyard for £10 and replaced it took 5 min easy job hope this helps
could be the speedo cable?
The clutch cable on a Peugeot 206 is self-adjusting. If it is not working right, then there is something broken. The auto adjuster is part of the clutch cable assembly, so a new clutch cable is required.
If the speedometer on your Peugeot Partner van isn't working after a clutch change, it could be due to a few issues. It's possible that the speed sensor was disconnected or damaged during the repair. Additionally, if the vehicle has a cable-driven speedometer, the cable might not have been reattached properly. Checking the connections and sensor functionality should help diagnose the problem.
Yes, or it's the plastic speedo gear that enters the transmission. An easy way to narrow it down between the speedo cable or the transmission gear is to disconnect the speedo cable from the transaxle (garden hose style), and attach the metal "key" end to your drill. Then spin the drill. If the speedometer reads like you were driving, then your cable is ok and it's your the gear in the transaxle. If the speedometer doesn't read anything, then your cable is broken and it's time for a new one.
speedo connected to gearbox and connected to other end not brken but not working
To repair the speedo cable on a Peugeot 205 GTI, start by disconnecting the battery and removing the instrument cluster to access the cable. Inspect the cable for any breaks or wear; if damaged, replace it with a new one. Reconnect the cable to both the speedometer and the transmission, ensuring it's securely fastened. Finally, reassemble the instrument cluster, reconnect the battery, and test the speedometer for proper function.