answersLogoWhite

0

What else can I help you with?

Related Questions

What are the cylinder head bolt torque settings on a volkswagen polo aev engine code?

polo torque settings 1200 engine main bearing


Vw polo 1.6 cylinder head torque settings?

The head torque settings for a VW Polo 1.6 cylinder head are 40 newton meters with 2- 90 degree turns. Bolts should always be replaced. It is not recommended to reuse the bolts.


What is torque settings for headbolts for 2002 model vw polo awy engine?

30 nms.then 60nms.then 90degrees .then90degrees.......


What are the torque settings for polo 1.4i?

For a Volkswagen Polo 1.4i, the torque settings can vary depending on the specific component being worked on. Generally, for cylinder head bolts, the torque specification is typically around 20 Nm (15 ft-lb) for initial tightening, followed by a further 90 degrees turn. For other components, such as wheel bolts, the torque setting is usually around 120 Nm (88 ft-lb). Always consult the vehicle's service manual for the most accurate specifications.


Remove air box housing vw polo 1.4?

how tremove aircon housing unit under the left glove comparmentona polo 1.6


What is the torque setting for VW Polo wheelnuts?

81 ftlb


Where can you buy thermostat housing for polo 1.4CL?

Needs to be ordered by the VW dealership!


Which is better vw polo or Skoda fabia?

Skoda Fabia , Better Build Quality , Rugged Look , Spacious than Polo , Better Engine Torque Vizay--


What are the cylinder head bolt torque setttings for polo classic 2003-2005?

For the Polo Classic from 2003 to 2005, the cylinder head bolt torque settings typically range from 20 Nm (15 lb-ft) for the initial stage, followed by a second stage of 40 Nm (29 lb-ft), and finally, a third stage that involves an additional 90 degrees of rotation. It's essential to follow the manufacturer's specific guidelines and sequences for tightening to ensure proper sealing and engine integrity. Always refer to a service manual for the most accurate and detailed torque specifications.


Polo playa 2001 where is resistor for fan speed?

in the bottom of the fan housing located on the passenger side footwell.


VW Polo 1.4 Petrol overheats after a few miles thermostate changed cooling system bled carefully heater full on brings the temperature down Cylindhd gasket OK Request suggestions to solve the problem?

check the thermostat housing isn't broken where the thermostat pin pushes on the plastic housing fault with polo's


Air filter change on vw polo 2003?

Remove the top to the air filter housing. The air filter housing can be found in the engine compartment. The air filter will easily lift out. Put the new air filter in.