0
What else can I help you with?
What is the torque setting for the valve cover on a TD5 land rover?
TD5 Engine rocker torque setting is 10Nm or 7lbft
What is the rear wheel bearing torque for a land rover discovery 1?
The rear wheel bearing torque for a Land Rover Discovery 1 is typically specified at around 200 Nm (147 lb-ft). It is important to follow the manufacturer's guidelines for proper torque settings to ensure safe and effective performance. Always consult the vehicle's service manual for the most accurate specifications and procedures.
Land rover freelander v6 2.5 cylinder head torque settings?
manual de torque
What are the torque settings for rover 414 wheel nuts?
something around 110Nm
Rover 75 cylinder head bolt torque settings?
THis ain't no question
89 range rover head torque settings?
95Nm then 180 degrees twice
What are the torque settings for a land rover discovery dig ends and mains three and a half liter?
The torque settings for the Land Rover Discovery's 3.5-liter engine can vary based on specific components, but generally, for the cylinder head bolts, the initial torque is around 30 Nm (22 lb-ft) followed by a final torque of approximately 90 Nm (66 lb-ft) in a specific sequence. For the main bearing caps, the torque setting typically ranges from 40 to 50 Nm (29 to 37 lb-ft). Always refer to the vehicle’s service manual for precise specifications and sequences for your specific model year.
What are the torque settings and tightening sequence for a 1.6 k series rover engine?
What_are_the_torque_settings_and_tightening_sequence_for_the_cylinder_head_bolts_on_a_Rover_200_K-series_engine
What are the head bolt torque settings on a 1998 range rover?
It should tell you in your Repair Manual. Don't have one go [http://www.themotorbookstore.com/land-rover-range-rover-manuals.html Here]
Torque settings for a cylinderhead on a Rover 400 v reg?
30 nm 180 degrees repeat 180 degrees.
Whats the cylinder head torque settings for a land rover 300 tdi?
The cylinder head torque settings for a Land Rover 300 DTI starts at 40Nm for all bolts. Then for M10 x 117 mm long 60 degrees, M12 x 100 mm long 60 degrees.
What torque settings are needed for a Rover 111 cylinder head?
stage1. 20Nm stage2. +180 degrees stage3. +180 degrees.
