answersLogoWhite

0

It is important to know the head bolt tightening sequence and the torque of a vehicle. For the Fiat Punto it is 20nm, 30nm, 90 degree turn, 90 degree turn, then in order 8,6,2,5,10,7,3,1,4,9.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Tell me what the bolt tightening sequence is on an inline Chevy 2 nova?

bolt tightening sequence on what part?


Head bolt tightning sequence?

There will be a diagram of this in every car's manual. -Follow that specific diagram to order of tightening and torque specs.


What is the 2.2 head bolt tightening sequence?

The 2.2L engine head bolt tightening sequence typically follows a specific pattern to ensure even clamping pressure. Start by tightening the bolts in a specific order, usually beginning from the center and moving outward in a spiral pattern. Each bolt should be tightened in stages, often first to a specified torque and then another round to a higher torque setting, following the manufacturer's specifications for the exact torque values. Always refer to the service manual for the precise sequence and torque specifications for your specific engine model.


What is the bolt tightening sequence for 48 hole flange?

48 hole bolt tightening seqence


What is the bolt pattern on a 2001 Pontiac Sunfire?

which one? The head bolts? Engine to transaxle? And, are you really asking what the tightening sequence and/or torque rating is?


What is the torque spec for 1995 dodge spirit cylinder head bolts and what is the sequence of bolt tightening?

45,65,65 ft lbs then 90 degrees.


What is the proper bolt tightening sequence for an 08 dyna outer primary cover?

The proper bolt tightening sequence for an 08 Dyna outer primary cover typically involves starting from the center and working your way outward in a crisscross pattern. This helps ensure even pressure across the cover. Begin by tightening the bolts to the specified torque in several steps, gradually increasing to the final torque specification recommended in the service manual. Always refer to the manufacturer's guidelines for the exact torque values and sequence.


What is the head bolt tightening sequence and torque for a 2004 forenza?

For a 2004 Suzuki Forenza, the head bolt tightening sequence typically follows a specific pattern to ensure even pressure across the cylinder head. The sequence generally involves tightening the bolts in a spiral pattern, starting from the center and moving outward. The initial torque specification is usually around 22 lb-ft, followed by an additional angle torque of 90 degrees. Always refer to the vehicle's service manual for the exact specifications and procedures.


What is the head bolt torque and tightening pattern for an 1986 Mitsubishi Mighty Max Pick-up Truck 2.0?

The cylinder head bolt torque specs for a Mitsubishi 2.0 or 2.6 is 65 to 72 ft. lbs. cold. Torque sequence is as follows.


What is the 292 head bolt tightening sequence?

Tighten in a criss cross pattern to 70 lb/ft of torque. Work slowly tightening a small amount at a time until you reach 70 pounds.


What is the proper torque specification for tightening a bike handlebar bolt?

The proper torque specification for tightening a bike handlebar bolt is typically between 5-7 Newton meters.


What is the recommended torque specification for tightening a bike seatpost bolt?

The recommended torque specification for tightening a bike seatpost bolt is typically between 5-7 Newton meters.